Skip to contentSkip to conversation

notes on 2.4 -> 2.6 upgrade with a Serial ATA root

DISCUSSION Eric Wong 2 participants 2 messages Nov 19, 2003

lore
Share & tools
lore

Eric Wong

author
#0 lore raw

When using the 2.4.22-xfs kernel (Knoppix -> Debian installation), our SATA root drive shows up as /dev/hdg, but under 2.6, it's now a SCSI device, /dev/sda. It took us a while to figure out what was wrong until we finally got a serial line and were able to read the boot message outputs.

This is the error message we got originally _before_ we appended "root=/dev/sda3" to our command-line:

VFS: Cannot open root device "2203" or unknown-block(34,3) Please append a correct "root=" boot option

I have a feeling this will take a lot of SATA users by surprise, so hopefully it'll be documented from now on.

Signature · 2 lines
Eric Wong                                        [email protected]
Petta Technologies                         [email protected]
#1 lore raw
Quoted 6 lines · Eric Wong

When using the 2.4.22-xfs kernel (Knoppix -> Debian installation), our SATA root drive shows up as /dev/hdg, but under 2.6, it's now a SCSI device, /dev/sda. It took us a while to figure out what was wrong until we finally got a serial line and were able to read the boot message outputs.

Quoted 8 lines

This is the error message we got originally _before_ we appended "root=/dev/sda3" to our command-line:

VFS: Cannot open root device "2203" or unknown-block(34,3) Please append a correct "root=" boot option

I have a feeling this will take a lot of SATA users by surprise, so hopefully it'll be documented from now on.

you can use SATA drives as scsi drives on 2.4.x kernels too (I use it
with 2.4.21-ac4), actually at least in my case it's better because when I try to use it as IDE drive the system freezes (during probing IDE, right after it prints out the info about disks).

erik