Skip to contentSkip to conversation

test10, hangs at aic79xx probing

DISCUSSION [email protected] 1 participant 1 message Nov 24, 2003

lore
Share & tools
lore
#0 lore raw

Hello!

machine hangs just after

hda: 78165360 sectors (40020 MB) w/2048KiB Cache, CHS=16383/255/63, UDMA(100)
hda: hda1 hda2 hda3 hda4 < hda5 hda6 hda7 >

next should be

scsi0 : Adaptec AIC79XX PCI-X SCSI HBA DRIVER, Rev 2.0.4

        <Adaptec 29320LP Ultra320 SCSI adapter>
        aic7901A: Ultra320 Wide Channel A, SCSI Id=7, PCI 33 or 66Mhz,

512 SCBs

(scsi0:A:0): 320.000MB/s transfers (160.000MHz DT|IU|QAS, 16bit)
(scsi0:A:1): 320.000MB/s transfers (160.000MHz DT|IU|QAS, 16bit)
  Vendor: IBM       Model: IC35L036UCDY10-0  Rev: S21E
  Type:   Direct-Access                      ANSI SCSI revision: 03
  Vendor: IBM       Model: IC35L036UCDY10-0  Rev: S21E
  Type:   Direct-Access                      ANSI SCSI revision: 03

no oops, no panic

I've also experienced troubles with this scsi controller in test9, kernel detected it normally, but
after reading from both disks simultaneously kernel printing huge amount of debug and refused to read with io error. exact info I sent to linux-scsi, if interested.
in test9 case, Justin Gibbs ([email protected]) suggested me to try drivers from
http://people.FreeBSD.org/~gibbs/linux/SRC/aic79xx-linux-2.6-20031106-tar.gz
and it helps. Untarring these drivers into test10 does not help, same hang after IDE partitions probing. 2.4.22 works ok. Tell me, if you need more info.

SY, Vladimir