MPC8266 Abatron config file
Does anyone have a configuration file which works with u=boot? I have a file which is good enough to communicate with the board and program the flash. However when I try to run u-boot (type go), the baud rate is not correct. It appears that it is 4X the configured rate. If I remove the Abatron and boot normally, everything works fine.
TIA
Signature · 2 lines
All things come to those who wait. Some of us just have to wait a little longer...
Quoted 5 lines · In message <[email protected]> you wrote:
Does anyone have a configuration file which works with u=boot? I have a file which is good enough to communicate with the board and program the flash. However when I try to run u-boot (type go), the baud rate is not correct. It appears that it is 4X the configured rate. If I remove the Abatron and boot normally, everything works fine.
Well, this is a setting which is definitely hardware (board) depen- dend. So if you don't give away any facts about your hardware it is impossible to help (actually it's probably impossible in general as this might be a custom board).
Best regards,
Wolfgang Denk
Signature · 5 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd at denx.de Every program has at least one bug and can be shortened by at least one instruction - from which, by induction, one can deduce that every program can be reduced to one instruction which doesn't work.
This is a standard ADS8266 board. The MPC8266 configuration file I am using has been posted to this list, although I do not see it on your FTP site. Essentially it is the same at the MPC8260 version that is on the site.
Quoted 16 lines · Wolfgang Denk
Quoted 5 lines · In message <[email protected]> you wrote:
Does anyone have a configuration file which works with u=boot? I have a file which is good enough to communicate with the board and program the flash. However when I try to run u-boot (type go), the baud rate is not correct. It appears that it is 4X the configured rate. If I remove the Abatron and boot normally, everything works fine.
Well, this is a setting which is definitely hardware (board) depen- dend. So if you don't give away any facts about your hardware it is impossible to help (actually it's probably impossible in general as this might be a custom board).
Best regards,
Wolfgang Denk
Signature · 2 lines
All things come to those who wait. Some of us just have to wait a little longer...