Skip to contentSkip to conversation

ISDN in 2.6.0-testX

DISCUSSION Paolo Ornati 1 participant 1 message Dec 4, 2003

lore
Share & tools
lore
#0 lore raw

Is anyone working to get ISDN (hisax driver ;) work in 2.6.0-textX kernels?

My problem is a "totally kernel freeze" trying to load hisax module... this happens in all 2.6.0-testX kernels.

My ISDN card: "Hamlet PCI ISDN CARD":

00:0d.0 Network controller: Cologne Chip Designs GmbH ISDN network controller [HFC-PCI] (rev 02)
Subsystem: Cologne Chip Designs GmbH ISDN Board
Flags: bus master, medium devsel, latency 16, IRQ 5 I/O ports at 8400 [disabled] [size=8]
Memory at df000000 (32-bit, non-prefetchable) [size=256]
Capabilities: [40] Power Management version 1

My CONFIG: (2.6.0-testX)

# ISDN subsystem
#
CONFIG_ISDN_BOOL=y

#
# Old ISDN4Linux
#
CONFIG_ISDN=y
CONFIG_ISDN_PPP=y
CONFIG_ISDN_PPP_VJ=y

#
# ISDN4Linux hardware drivers
#

#
# Passive cards
#
CONFIG_ISDN_DRV_HISAX=m

#
# D-channel protocol features
#
CONFIG_HISAX_EURO=y
CONFIG_HISAX_MAX_CARDS=1

#
# HiSax supported cards
#
CONFIG_HISAX_HFC_PCI=y

PROBLEM DESCRIPTION:
when I try to load the "hisax" module the kernel freezes, I can only push the reset button.
The last line printed is "HFC_PCI: resetting card".

Using some "printk" I found the point where the freeze happens:

drivers/isdn/hisax/hfc_pci.c --> hfcpci_reset(struct IsdnCardState *cs)
...

        /* Finally enable IRQ output */
        cs->hw.hfcpci.int_m2 = HFCPCI_IRQ_ENABLE;
        Write_hfc(cs, HFCPCI_INT_M2, cs->hw.hfcpci.int_m2);        <-- HERE!
        if (Read_hfc(cs, HFCPCI_INT_S2));

...

So the problem happens trying to enable IRQ on the ISDN Card.... Has anyone an idea of what can be wrong?
(The problem isn't about CONFIG_PREEMPT because I try with and without it).

Bye

Signature · 2 lines
	Paolo Ornati
	Linux v2.4.23