Skip to contentSkip to conversation

kernel can't boot

DISCUSSION sun-zj 2 participants 2 messages Dec 29, 2003

lore
Share & tools
lore

sun-zj

author
#0 lore raw

Hi, Denk:

Thank you for your wise instructions. I do as told . After I clear the clock_in_mhz environment variable
the kernel boot. It goes well. Thanks again. :)
Our board use the Intel Flash 28F320C3T which driver for linux is not available now. I found that
on the www including the mtd base org. But nothing.
I wonder if I want to develop the driver for myself,
what should I do for the kernel?

Appreciate your kind help

Best regard

Zongjun Sun

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

#1 lore raw
Quoted 4 lines · In message <[email protected]> you wrote:

Thank you for your wise instructions. I do as told . After I clear the clock_in_mhz environment variable the kernel boot. It goes well. Thanks again. :)

You are welcome.

Quoted 2 lines

Our board use the Intel Flash 28F320C3T which driver for linux is not available now. I found that

What makes you think so? This flash chip is used on a couple of boards and the existing Linux drivers work fine with it.

Quoted 2 lines

I wonder if I want to develop the driver for myself, what should I do for the kernel?

Nothing.

Best regards, and a Happy New Year!

Wolfgang Denk

--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: [email protected] To be a winner, all you need to give is all you have.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/