Kernel bug with BIOS

Hi to all!

I'm user of ALTLinux Sisyphus. I have kernel 2.4.22 installed on. And I have PCMCIA Network Card installed on Acer TravelMate 723TXV. My friend gave me USB Flash Disk (PQI Travelling Disk, 32Mb).

When I try to plug it, my system halts. Ok, then I unplug my PCMCIA NetCard and reboots. Then I retry to plug it. And... my system don't see this FlashDisk! I looking at "dmesg | more":

---------------------------------------------------------------------
hub.c: new USB device 00:04.2-1, assigned address 2 usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=2 (error -110) hub.c: new USB device 00:04.2-1, assigned address 3 usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=3 (error -110)
---------------------------------------------------------------------

After I booting my system a new I see at "dmesg | more" again:

---------------------------------------------------------------------
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 22:00:15 Nov 29 2003 usb-uhci.c: High bandwidth mode enabled
PCI: Found IRQ 11 for device 00:04.2
IRQ routing conflict for 00:04.2, have irq 9, want irq 11 usb-uhci.c: USB UHCI at I/O 0xfce0, IRQ 9
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
---------------------------------------------------------------------

I tryed to search info about this problem - there are many letter with this question but no more answers in the Web. I find only one letter from <[email protected]> to [email protected], dated by Sun, 04 Nov 2001 15:13:56 +0100:

---------------------------------------------------------------------
<skipped>
That's interesting. It's obivously a bios bug:
The USB controller only supports interrupt 9 (mask==0x200 -->bit 9), is right now running on irq 9 according to the bios data.
But according to the piix irq router, it's connected to irq 10.

First we must figure out where the bios lies. Could you try the attached patches?
The patches are alternatives, first try option 1, then option 2.

--

@@ -626,7 +626,7 @@
 			continue;
 		if (info->irq[pin].link == pirq) {
 			/* We refuse to override the dev->irq information. Give a warning! */
-		    	if (dev2->irq && dev2->irq != irq) {
+		    	if (dev2->irq && dev2->irq != irq && 0) {
 		    		printk(KERN_INFO "IRQ routing conflict for %s, have irq %d, want irq %d\n",
 				       dev2->slot_name, dev2->irq, irq);
 		    		continue;

@@ -629,6 +629,18 @@
 		    	if (dev2->irq && dev2->irq != irq) {
 		    		printk(KERN_INFO "IRQ routing conflict for %s, have irq %d, want irq %d\n",
 				       dev2->slot_name, dev2->irq, irq);
+				if (!strcmp(msg, "Found")) {
+					/* ok, the bios lied. Try to recover */
+					if (r->set && (dev->class >> 8) != PCI_CLASS_DISPLAY_VGA) {
+						printk(KERN_ERR "trying set.\n");
+						if (r->set(pirq_router_dev, dev2, pirq, dev2->irq)) {
+							printk(KERN_ERR "set succedded.\n");
+							eisa_set_level_irq(dev2->irq);
+						} else {
+							printk(KERN_ERR "set failed.\n");
+						}
+					}
+				}
 		    		continue;
 		    	}
 			dev2->irq = irq;

---------------------------------------------------------------------

I tryed to use patch No 2 with kernel-2.4.21 and it really works: no conflicts, all works and Linux work with Travelling Disk on my Acer TravelMate. But why this patch is not applied to kernel? I think, this is not only my problem, but some peoples too.

X-Stranger,
http://Linux.by Administrator

P.S. Sorry, my English isn't well. ;))