Skip to contentSkip to conversation

What SCSI in the IBM?

DISCUSSION Robert L. Harris 4 participants 6 messages Jan 9, 2004 – Jan 15, 2004 3 messages not in the archive

lore
Share & tools
lore
#0 lore raw

The network cards in this IBM came up great once I found the right port. Now though I'm trying to find what SCSI driver to use. lspci reports "Symbios Logic unknown device (Formerly NCR)" but if I do a modprobe on all 3 drivers as well as the one ncr driver no go. All of them report no such device except the sym53c416 which says unresolved symbol:

isapnp-find-dev.

Thoughts?

:wq!
---------------------------------------------------------------------------
Robert L. Harris | GPG Key ID: E344DA3B

                                         @ x-hkp://pgp.mit.edu

DISCLAIMER:
These are MY OPINIONS ALONE. I speak for no-one else.

Life is not a destination, it's a journey.
Microsoft produces 15 car pileups on the highway.
Don't stop traffic to stand and gawk at the tragedy.

#1 lore raw
Quoted 2 lines · Robert L. Harris

The network cards in this IBM came up great once I found the right port. Now though I'm trying to find what SCSI driver to use.

What IBM? Laptop? PC? Netfinity? RS6K? e/i/p/z-series?

#2 lore raw

Thus spake [email protected] ([email protected]):

Quoted 6 lines · Robert L. Harris
Quoted 3 lines

The network cards in this IBM came up great once I found the right port. Now though I'm trying to find what SCSI driver to use.

What IBM? Laptop? PC? Netfinity? RS6K? e/i/p/z-series?

Ok, I found the "isa-pnp" module which fixed the unresolved module but now the sym driver also just give no device errors. This is a 2U Xeon "eServer" model number x345.

:wq!
---------------------------------------------------------------------------
Robert L. Harris | GPG Key ID: E344DA3B

                                         @ x-hkp://pgp.mit.edu

DISCLAIMER:
These are MY OPINIONS ALONE. I speak for no-one else.

Life is not a destination, it's a journey.
Microsoft produces 15 car pileups on the highway.
Don't stop traffic to stand and gawk at the tragedy.

#3 lore raw

I have a few x345s at work. This should help.

It is a LSI Logic / Symbios Logic (formerly NCR) card.

Here are the SCSI files that I know are =y in my .config:

CONFIG_SCSI=y
CONFIG_SCSI_DEBUG_QUEUES=y
CONFIG_SCSI_MULTI_LUN=y
CONFIG_SCSI_CONSTANTS=y
CONFIG_SCSI_AACRAID=y
CONFIG_SCSI_AIC7XXX=y
CONFIG_SCSI_DPT_I2O=y
CONFIG_SCSI_G_NCR5380_PORT=y
CONFIG_SCSI_SYM53C8XX=y
CONFIG_SCSI_NCR53C8XX_PQS_PDS=y
CONFIG_SCSI_DC390T=y
CONFIG_SCSI_PCMCIA=y
CONFIG_I2O_SCSI=y

Sorry this list is not a clean as I would like.

I also know there is a debian add-on disk with the needed modules for this card, but I don't have an extra machine to try that on right now to look them up.

jlogan@host:~$ cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 00 Lun: 00
  Vendor: LSILOGIC Model: 1030 IM          Rev: 1000
  Type:   Direct-Access                    ANSI SCSI revision: 02
Host: scsi0 Channel: 00 Id: 08 Lun: 00
  Vendor: IBM      Model: 32P0032a S320  1 Rev: 1
  Type:   Processor                        ANSI SCSI revision: 02
jlogan@host:~$ lspci
00:00.0 Host bridge: ServerWorks: Unknown device 0014 (rev 32)
00:00.1 Host bridge: ServerWorks: Unknown device 0014
00:00.2 Host bridge: ServerWorks: Unknown device 0014
00:06.0 VGA compatible controller: ATI Technologies Inc Rage XL (rev 27)
00:0f.0 Host bridge: ServerWorks CSB5 South Bridge (rev 93)
00:0f.1 IDE interface: ServerWorks CSB5 IDE Controller (rev 93)
00:0f.2 USB Controller: ServerWorks OSB4/CSB5 OHCI USB Controller (rev 05)
00:0f.3 ISA bridge: ServerWorks: Unknown device 0225
00:10.0 Host bridge: ServerWorks: Unknown device 0101 (rev 05)
00:10.2 Host bridge: ServerWorks: Unknown device 0101 (rev 05)
00:11.0 Host bridge: ServerWorks: Unknown device 0101 (rev 05)
00:11.2 Host bridge: ServerWorks: Unknown device 0101 (rev 05)
06:08.0 Ethernet controller: Intel Corp.: Unknown device 1010 (rev 01)
06:08.1 Ethernet controller: Intel Corp.: Unknown device 1010 (rev 01)
08:07.0 SCSI storage controller: LSI Logic / Symbios Logic (formerly NCR)
53c1030 (rev 07)
08:07.1 SCSI storage controller: LSI Logic / Symbios Logic (formerly NCR)
53c1030 (rev 07)

Hope this helps.

Later, JOSH

Quoted 26 lines · Robert L. Harris

Thus spake [email protected] ([email protected]):

Quoted 6 lines · Robert L. Harris
Quoted 3 lines

The network cards in this IBM came up great once I found the right port. Now though I'm trying to find what SCSI driver to use.

What IBM? Laptop? PC? Netfinity? RS6K? e/i/p/z-series?

Ok, I found the "isa-pnp" module which fixed the unresolved module but now the sym driver also just give no device errors. This is a 2U Xeon "eServer" model number x345.

:wq!
---------------------------------------------------------------------------
Robert L. Harris | GPG Key ID: E344DA3B

                                         @ x-hkp://pgp.mit.edu

DISCLAIMER:
These are MY OPINIONS ALONE. I speak for no-one else.

Life is not a destination, it's a journey.
Microsoft produces 15 car pileups on the highway.
Don't stop traffic to stand and gawk at the tragedy.

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

#7 lore raw

On the money. Thank you.

Robert

Thus spake Dave Gilbert (Home) ([email protected]):

Quoted 8 lines
Quoted 2 lines · Robert L. Harris

So this is the "Fusion MPT" that's off the main menu?

Yep thats the one. Works a treat!

Dave

:wq!
---------------------------------------------------------------------------
Robert L. Harris | GPG Key ID: E344DA3B

                                         @ x-hkp://pgp.mit.edu

DISCLAIMER:
These are MY OPINIONS ALONE. I speak for no-one else.

Life is not a destination, it's a journey.
Microsoft produces 15 car pileups on the highway.
Don't stop traffic to stand and gawk at the tragedy.

#8 lore raw
In reply to Robert L. Harris
Quoted 9 lines · Robert L. Harris

Thus spake [email protected] ([email protected]):

Quoted 6 lines · Robert L. Harris
Quoted 4 lines

The network cards in this IBM came up great once I found the right port. Now though I'm trying to find what SCSI driver to use.

Quoted 6 lines
Quoted 1 line

What IBM? Laptop? PC? Netfinity? RS6K? e/i/p/z-series?

Ok, I found the "isa-pnp" module which fixed the unresolved module but now the sym driver also just give no device errors. This is a 2U Xeon "eServer" model number x345.

Unfortunately all mine have ServRAID cards to do the SCSI ops, so I have no idea. However:

$ lspci
00:00.0 Host bridge: ServerWorks: Unknown device 0012 (rev 13)
00:00.1 Host bridge: ServerWorks: Unknown device 0012
00:00.2 Host bridge: ServerWorks: Unknown device 0000
00:05.0 Bridge: IBM: Unknown device 010f
00:06.0 VGA compatible controller: ATI Technologies Inc Rage XL (rev 27)
00:0f.0 Host bridge: ServerWorks CSB5 South Bridge (rev 93)
00:0f.1 IDE interface: ServerWorks CSB5 IDE Controller (rev 93)
00:0f.2 USB Controller: ServerWorks OSB4/CSB5 USB Controller (rev 05)
00:0f.3 ISA bridge: ServerWorks: Unknown device 0225
00:10.0 Host bridge: ServerWorks: Unknown device 0101 (rev 03)
00:10.2 Host bridge: ServerWorks: Unknown device 0101 (rev 03)
00:11.0 Host bridge: ServerWorks: Unknown device 0101 (rev 03)
00:11.2 Host bridge: ServerWorks: Unknown device 0101 (rev 03)
02:03.0 RAID bus controller: IBM Netfinity ServeRAID controller
06:08.0 Ethernet controller: Intel Corp. 82546EB Gigabit Ethernet Controller (rev 01)
06:08.1 Ethernet controller: Intel Corp. 82546EB Gigabit Ethernet Controller (rev 01)
08:02.0 RAID bus controller: IBM Netfinity ServeRAID controller

is what I show. I guess that doesn't help.

Signature · 3 lines
bill davidsen <[email protected]>
  CTO TMR Associates, Inc
  Doing interesting things with small computers since 1979