Skip to contentSkip to conversation

HP1825 and PCI Vis-EG at 1600x1200

parisc-linux Grant Grundler 2 participants 3 messages Feb 4, 2004 – Feb 17, 2004

lore
Share & tools
lore
#0 lore raw

I just recently got an HP 1825 Flat panel display.
The documentation says the panel supports 1600x1200 resolution via analog (not DVI) input at 75Khz Hsync, 60Hz refresh (Vsync).

Anyone already know if PCI Vis-EG card can output that? If so how? Maybe some sort of custom "mode line" in PDC? I'm looking for concrete steps, not speculation.

I'll hunt a bit more on the internet since I'm pretty sure I've seen some of the HP parisc workstations allow for a "custom" video output but don't know if Vis-EG allows that or where the steps to do it are described.

thanks,
grant

#1 lore raw
Quoted 3 lines

I just recently got an HP 1825 Flat panel display.
The documentation says the panel supports 1600x1200 resolution via analog (not DVI) input at 75Khz Hsync, 60Hz refresh (Vsync).

I tried 1600x1200 @ 75Hz on a NEC LCD. However, I found that the redraw time with the VIS-EG was too long for my taste. I settled for 1280x1024 @ 75 Hz.

Quoted 3 lines

Anyone already know if PCI Vis-EG card can output that? If so how? Maybe some sort of custom "mode line" in PDC? I'm looking for concrete steps, not speculation.

The C3k manual describes the commands needed to the Vis-EG to its predefined modes.

Quoted 4 lines

I'll hunt a bit more on the internet since I'm pretty sure I've seen some of the HP parisc workstations allow for a "custom" video output but don't know if Vis-EG allows that or where the steps to do it are described.

If I recall, there is a line in the list of settings for the Vis-EG for user defined settings. However, I couldn'd figure out how to set them.

Dave

Signature · 2 lines
J. David Anglin                                  [email protected]
National Research Council of Canada              (613) 990-0752 (FAX: 952-6602)
#2 lore raw
Quoted 8 lines · John David Anglin
Quoted 4 lines

I'll hunt a bit more on the internet since I'm pretty sure I've seen some of the HP parisc workstations allow for a "custom" video output but don't know if Vis-EG allows that or where the steps to do it are described.

If I recall, there is a line in the list of settings for the Vis-EG for user defined settings. However, I couldn'd figure out how to set them.

Yup, that's exactly what I was looking for.
I've seen that once upon a time but it might have been
on an HP internal website for a different card.
My fear is I have to run HPUX and "setmon" to get the custom settings.

Anyway, I gave up on this since it looks the manual for the "HP 1825" really only supports 1280x1024 and the manual is derived or shared with the "HP 2025" (20") flat panel display. Thus the comment about 1600x1200 probably only applies to the 20" display.

thanks,
grant