Remove CONFIG_SCSI_DC390T_NOGENSUPP
PATCH 1/1 Remove CONFIG_SCSI_DC390T_NOGENSUPP
Now that the Am53C974 driver is gone it doesn't make sense to not support all Am53C974-based cards, and the amount of code under the ifdef is tiny anyways.
drivers/scsi/Kconfig +0 -19
@@ -1250,28 +1250,9 @@ Note that this driver does NOT support Tekram DC390W/U/F, which are based on NCR/Symbios chips. Use "NCR53C8XX SCSI support" for those. - Also note that there is another generic Am53C974 driver, - "AM53/79C974 PCI SCSI support" below. You can pick either one. To compile this driver as a module, choose M here: the module will be called tmscsim. - -config SCSI_DC390T_NOGENSUPP - bool "_omit_ support for non-DC390 adapters" - depends on SCSI_DC390T - ---help--- - If you say N here, the DC390(T) SCSI driver relies on the DC390 - EEPROM to get initial values for its settings, such as speed, - termination, etc. If it can't find this EEPROM, it will use - defaults or the user supplied boot/module parameters. For details - on driver configuration see <file:Documentation/scsi/tmscsim.txt>. - - If you say Y here and if no EEPROM is found, the driver gives up and - thus only supports Tekram DC390(T) adapters. This can be useful if - you have a DC390(T) and another Am53C974 based adapter, which, for - some reason, you want to drive with the other AM53C974 driver. - - If unsure, say N. config SCSI_T128 tristate "Trantor T128/T128F/T228 SCSI support"
drivers/scsi/tmscsim.c +0 -7
@@ -518,7 +518,6 @@ } -#ifndef CONFIG_SCSI_DC390T_NOGENSUPP int __initdata tmscsim_def[] = {7 ,0 /* 10MHz */ ,PARITY_CHK_ |SEND_START_ |EN_DISCONNECT_ |SYNC_NEGO_ |TAG_QUEUEING_ ,
@@ -546,7 +545,6 @@if (tmscsim[4 ] >5 ) tmscsim[4 ] =4 ;if (tmscsim[5 ] >180 ) tmscsim[5 ] =180 ; } -#endif /* Override defaults on cmdline: * tmscsim: AdaptID, MaxSpeed (Index), DevMode (Bitmapped), AdaptMode (Bitmapped)
@@ -2105,10 +2103,6 @@if (dc390_CheckEEpromCheckSum (PDEV , index)) { -#ifdef CONFIG_SCSI_DC390T_NOGENSUPP -printk (KERN_ERR "DC390_init: No EEPROM found!\n" ); -return (-1 ); -#else int speed; dc390_adapname ="AM53C974" ;printk (KERN_INFO "DC390_init: No EEPROM found! Trying default settings ...\n" );
@@ -2120,7 +2114,6 @@" DevMode=0x%02x, AdaptMode=0x%02x, TaggedCmnds=%i (%i), DelayReset=%is\n" , tmscsim[0 ], tmscsim[1 ], speed/10 , speed%10 , (UCHAR)tmscsim[2], (UCHAR)tmscsim[3], tmscsim[4], 2 << (tmscsim[4]), tmscsim[5]); -#endif }else {