2.4.24 Via audio driver.
Can anyone offer any possible debug tips for tracing a problem with the Via Audio driver under 2.4.24?
Before anyone asks, I already tried using the email address in the maintainers list ([email protected]) - that address is invalid - no such user.
The problem is that the audio driver appears to not be initializing the DSP correctly. Thus, I get no audio out.
Here is the relevent lines from dmesg:
root@db:~# dmesg | grep -i via PCI: Using IRQ router VIA [1106/3177] at 00:11.0 via-rhine.c:v1.10-LK1.1.19 July-12-2003 Written by Donald Becker http://www.scyld.com/network/via-rhine.html eth0: VIA VT6102 Rhine-II at 0xa800, 00:0c:6e:74:2a:03, IRQ 9. agpgart: Detected Via Apollo Pro KT400 chipset VP_IDE: VIA vt8235 (rev 00) IDE UDMA133 controller on pci00:11.1 Via 686a/8233/8235 audio driver 1.9.1-ac3 via82cxxx: Six channel audio available via82cxxx: timeout while reading AC97 codec (0x8000000) via82cxxx: board #1 at 0xE000, IRQ 9
Note that I already have tried the following in via_ac97_wait_idle (via82cxxx.c): changing the usleep value from 15 to 150 - no difference.
Here is the dump from lspci -vv
00:11.5 Multimedia audio controller: VIA Technologies, Inc. VT8233 AC97 Audio Controller (rev 50)
Subsystem: Asustek Computer, Inc.: Unknown device 80a1
Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin C routed to IRQ 9
Region 0: I/O ports at e000 [size=256]
Capabilities: [c0] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mAPME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Thanks for your time and help!
Signature · 10 lines
Ronald R. Gage MCP, LPIC1, A+, Net+ Pontiac, Michigan ---------------------------------------------------------------- This message was sent using webmail provided by www.rongage.org