Skip to contentSkip to conversation

U-Boot and S3c2410

U-Boot-Users Wolfgang Denk 1 participant 1 message Feb 23, 2004 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 1 line · In message <[email protected]> you wrote:

So what is the difference between the load and entry addresses? All

The load address is where the kernel gets loaded into RAM when you run the "bootm" command, and the entry point address is the address - um - of the entrypoint, i. e. the first exacutable instruction.

Quoted 2 lines

of the examples I've seen have the load and entry addresses set to be the same...ish. 0x00000000 & 0x0000000c for PPC

Wong. Both are 0x000 on PowerPC by default.

Quoted 4 lines

In my case my SDRAM starts at 0x30000000 and ends at 0x33FFFFFF. My Flash and hence U-Boot is at 0x00.

Does the load and entry address vary depending on whether you are using vmlinux/vmlinux compressed/zImage?

It depends on what your Linux kernel's linker script does. I don;t know your kernel source tree, so I have no idea which values are correct for you.

Best regards,

Wolfgang Denk

Signature · 5 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
FORTRAN? The syntactically incorrect statement "DO 10 I = 1.10"  will
parse  and  generate  code  creating  a  variable, DO10I, as follows:
"DO10I = 1.10" If that doesn't terrify you, it should.