add lowpower_idle sysctl
<snip>
Quoted 7 lines
OK, so why not give us:
#define
IDLE_HALT0
#defineIDLE_POLL1
#defineIDLE_SUPER_LOW_POWER_HALT2and so forth (are there any others?).
#define IDLE_C1HALT ?
I created another one for Athlon Nforce2 to prevent lockups in apic mode. It is proving more useful than I thought.
It has also been used on SIS740 to prevent same problem.
I know such a workaround should not be required but it works well.
It modifies C1 state idle behaviour by being a little more intelligent about when it is worthwhile to do into disconnect and has a crude but effective delay in case of back to back disconnect reconnect cycles. Recent post.
http://linux.derkeiler.com/Mailing-Lists/Kernel/2004-03/4278.html
Patch is here.
http://linux.derkeiler.com/Mailing-Lists/Kernel/2004-02/6520.html
Currently it is kernel arg activated by "idle=C1halt".
Quoted 3 lines
Set some system-wide integer via a sysctl and let the particular architecture decide how best to implement the currently-selected idle mode?
A lockup detector on Athlon systems could conceivably invoke above idle state after a manual reboot as not all systems of the same chipset have the problem.
Ross.