Firewire broken in 2.6.4 (detects disk but times out mounting)
Here's what happens:
Mar 19 22:00:47 hellhound ieee1394: sbp2: Logged into SBP-2 device Mar 19 22:00:47 hellhound ieee1394: sbp2: Node 0-00:1023: Max speed [S400] - Max payload [2048] Mar 19 22:00:47 hellhound Vendor: Maxtor Model: 5000DV Rev: 0100 Mar 19 22:00:47 hellhound Type: Direct-Access ANSI SCSI revision: 06 Mar 19 22:00:47 hellhound SCSI device sda: 490232832 512-byte hdwr sectors (250999 MB) Mar 19 22:00:47 hellhound sda: asking for cache data failed Mar 19 22:00:47 hellhound sda: assuming drive cache: write through Mar 19 22:00:47 hellhound /dev/scsi/host0/bus0/target1/lun0: p1 Mar 19 22:00:47 hellhound Attached scsi disk sda at scsi0, channel 0, id 1, lun 0 Mar 19 22:00:47 hellhound ip1394: $Rev: 1175 $ Ben Collins <[email protected]> Mar 19 22:00:47 hellhound ip1394: eth2: IEEE-1394 IPv4 over 1394 Ethernet (fw-host0) [...] Mar 19 22:01:21 hellhound ieee1394: sbp2: aborting sbp2 command Mar 19 22:01:21 hellhound 0x28 00 00 00 00 3f 00 00 01 00 Mar 19 22:01:31 hellhound ieee1394: sbp2: aborting sbp2 command Mar 19 22:01:31 hellhound 0x00 00 00 00 00 00 Mar 19 22:01:31 hellhound ieee1394: sbp2: reset requested Mar 19 22:01:31 hellhound ieee1394: sbp2: Generating sbp2 fetch agent reset Mar 19 22:01:41 hellhound ieee1394: sbp2: aborting sbp2 command Mar 19 22:01:41 hellhound 0x00 00 00 00 00 00 Mar 19 22:01:41 hellhound ieee1394: sbp2: reset requested Mar 19 22:01:41 hellhound ieee1394: sbp2: Generating sbp2 fetch agent reset Mar 19 22:02:01 hellhound ieee1394: sbp2: aborting sbp2 command Mar 19 22:02:01 hellhound 0x00 00 00 00 00 00 Mar 19 22:02:01 hellhound ieee1394: sbp2: reset requested Mar 19 22:02:01 hellhound ieee1394: sbp2: Generating sbp2 fetch agent reset Mar 19 22:02:21 hellhound ieee1394: sbp2: aborting sbp2 command Mar 19 22:02:21 hellhound 0x00 00 00 00 00 00 Mar 19 22:02:21 hellhound scsi: Device offlined - not ready after error recovery: host 0 channel 0 id 1 lun 0 Mar 19 22:02:21 hellhound SCSI error : <0 0 1 0> return code = 0x50000 Mar 19 22:02:21 hellhound end_request: I/O error, dev sda, sector 63 Mar 19 22:02:21 hellhound FAT: unable to read boot sector
Any idea? It is not a general read failure since reading the partition table worked. This is on a VIA Athlon XP board.
Felix