Skip to contentSkip to conversation

PROBLEM: APIC on Chaintech ZNF3-150 Motherboard

DISCUSSION Ross Dickson 1 participant 1 message Mar 23, 2004

lore
Share & tools
lore
#0 lore raw
Quoted 18 lines · Doug Winter
Quoted 11 lines

I've just put a new computer together with an AMD Athlon 64 3200+ and a Chaintech ZNF3-150 motherboard. This has the Nvidia NForce 3 chipset.

Booting 2.6.4, from the debian kernel-image-2.6.4-1-k7 package, I get reproducible errors from the onboard BCM5788 NIC and a Realtek 8139 NIC when under load.

When the disk is under load, I get reproducible DMA errors from any IDE disk that is under load.

When I boot with "noapic", these problems go away.

NVidia chipsets are known to have problems when used with local APIC or I/O-APIC. We don't know exactly what happens, but it looks like a hardware or BIOS problem. The only known cure is to try combinations of:

Quoted 7 lines

upgrade BIOS
pci=noacpi
acpi=off
noapic
nolapic

FWIW, VIA's K8T800 chipset seems to work very well.

Perhaps I should ask firstly how your timer interrupts are routed? io-apic edge, local apic, or xtpic - does it still have one of these?

And you could check and see whether this patch has made it through to your current kernel (I just remember the posting - I don't have an nforce3).
http://linux.derkeiler.com/Mailing-Lists/Kernel/2004-02/1648.html
http://linux.derkeiler.com/Mailing-Lists/Kernel/2004-02/1604.html

I don't know about idle states for K8 and nforce3 but you could also try my C1 idle halt patch (for K7 and Nforce2 - also SiS740). It may have no effect on nforce3 but you might get lucky (don't forget the kernel arg or it won't work).
http://linux.derkeiler.com/Mailing-Lists/Kernel/2004-02/6520.html
The io-apic patch there may also help route the timer interrupts via IO-apic assuming nvidia followed nforce2 methods.

Please CC me with your responses.
Regards
Ross.