Skip to contentSkip to conversation

sample rate rule problems

DISCUSSION Giuliano Pochini 1 participant 1 message May 16, 2004

lore
Share & tools
lore
#0 lore raw

I'm trying to write a rule for the Layla24. That card supports all standard sample rates 8KHz-96KHz and continuous rates only in the range 25KHz-100KHz. I wrote this rule, but ALSA gets confused and it sometimes chooses a wrong value, sometimes fails. I can't figure out why. This is the rule:

{
	snd_interval_t *rate = hw_param_interval(params, SNDRV_PCM_HW_PARAM_RATE);
	unsigned int rates[] = {8000, 11025, 16000, 22050, 32000, 44100, 48000, 88200, 96000, 0};
	int r;

	printk("req min=%d max=%d\n",rate->min,rate->max);

	if (rate->max < 25000) {
		printk("list\n");
		return snd_interval_list(rate, 4, rates, 0);
	}

	if (rate->min >= 25000 && rate->min == rate->max) {
		/* If it's a standard rate, do nothing */
		for (r = 0; rates[r]; r++)
			if (rates[r] == rate->min)
				return(0);
		printk("cont\n");
		params->rate_num = LAYLA24_MAGIC_NUMBER;
		params->rate_den = LAYLA24_MAGIC_NUMBER / rate->min;
	}
	return 0;
}

If it is a standard sample rate or it's in the continuous range, it's all right. Otherwise snd_pcm_hw_params_set_rate_near() fails:

[Giu@Jay Giu]$ aplay -v -f S32_LE -c 2 -r 11020 -D hw:0,0,2 booo.html Playing raw data 'wget' : Signed 32 bit Little Endian, Rate 11020 Hz, Stereo
aplay: aplay.c:824: set_params: Assertion `err >= 0' failed.

--
Giuliano.

-------------------------------------------------------
This SF.Net email is sponsored by: SourceForge.net Broadband Sign-up now for SourceForge Broadband and get the fastest 6.0/768 connection for only $19.95/mo for the first 3 months!
http://ads.osdn.com/?ad_id=2562&alloc_id=6184&op=click