Skip to contentSkip to conversation

how to route based on link load?

LARTC Birger Schmidt 1 participant 1 message Jun 2, 2004

lore
Share & tools
lore
#0 lore raw

hello,

i want to know if there is any method to route traffic based on the load of a link.
imagine the following scenario:

 +----------+     +------+        +------+     +----------+
 | subnet 1 |#####| rt 1 |--------| rt 2 |#####| subnet 2 |
 +----------+     +------+        +------+     +----------+
                       \            /
                        \ +------+ /
                         \| rt 3 |/
                          +------+

the bandwidth of the links is as follows:
sn1 - rt1 100mbit
sn2 - rt2 100mbit
rt1 - rt2 - rt3 10mbit
now there are multiple flows from sn1 to sn2.
if the load on the prefered link (rt1-rt2) is 80% or more i want to utilisize the rt1-rt3-rt2 route as well. but only in this case - not normaly.
so i think ecmp with weights is not the solution to this.

anyone out there who can point me in the right direction?

thanx in advance

bye bye birger

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/