adm1025 driver ported to 2.6
PATCH 1/1 adm1025 driver ported to 2.6
Hi Greg,
This is my port of the adm1025 driver to 2.6. It has been tested by a few users and reported to work OK.
I was almost certain to have sent it to you and on the list already, but it seems that I've only been *dreaming* I was sending it...
Please apply,
thanks.
Signed-off-by Jean Delvare <khali at linux-fr dot org>
drivers/i2c/chips/Kconfig renamed from drivers/i2c/chips.orig/Kconfig +10 -0
@@ -22,6 +22,16 @@ This driver can also be built as a module. If so, the module will be called adm1021. +config SENSORS_ADM1025 + tristate "Analog Devices ADM1025 and compatibles" + depends on I2C && EXPERIMENTAL + select I2C_SENSOR + help + If you say yes here you get support for Analog Devices ADM1025 + and Philips NE1619 sensor chips. + This driver can also be built as a module. If so, the module + will be called adm1025. + config SENSORS_ADM1031 tristate "Analog Devices ADM1031 and compatibles" depends on I2C && EXPERIMENTAL
drivers/i2c/chips/Makefile renamed from drivers/i2c/chips.orig/Makefile +1 -0
@@ -8,6 +8,7 @@ obj-$(CONFIG_SENSORS_W83781D) += w83781d.o obj-$(CONFIG_SENSORS_ADM1021) += adm1021.o +obj-$(CONFIG_SENSORS_ADM1025) += adm1025.o obj-$(CONFIG_SENSORS_ADM1031) += adm1031.o obj-$(CONFIG_SENSORS_DS1621) += ds1621.o obj-$(CONFIG_SENSORS_EEPROM) += eeprom.o
drivers/i2c/chips/adm1025.c renamed from drivers/i2c/chips.orig/adm1025.c +570 -0
570 lines not on this page · raw message
Signature · 2 lines
Jean Delvare http://khali.linux-fr.org/
Greg KH
AppliedPATCH 1/1 adm1025 driver ported to 2.6
Quoted 9 lines · Jean Delvare
Hi Greg,
This is my port of the adm1025 driver to 2.6. It has been tested by a few users and reported to work OK.
I was almost certain to have sent it to you and on the list already, but it seems that I've only been *dreaming* I was sending it...
Please apply,
Applied, thanks.
greg k-h