pci/cpci_hotplug_core: replace
Subsystems (3)
PATCH 1/1 pci/cpci_hotplug_core: replace
I would appreciate any comments from the janitors list. This is one (of many) cases where I made a decision about replacing
set_current_state(TASK_INTERRUPTIBLE);schedule_timeout(some_time);
with
msleep(jiffies_to_msecs(some_time));
msleep() is not exactly the same as the previous code, but I only did this replacement where I thought long delays were *desired*. If this is not the case here, then just disregard this patch.
Thanks,
Nish
Applys-to: 2.6.7
Description: Uses msleep() instead of schedule_timeout() to guarantee the task delays the desired time.
Signed-off-by Nishanth Aravamudan <[email protected]>
drivers/pci/hotplug/cpci_hotplug_core.c +7 -10
@@ -513,11 +513,10 @@ event_thread(void *data)break ;while (controller->ops->query_enum ()) { rc =check_slots (); -if (rc >0 ) { +if (rc >0 )/* Give userspace a chance to handle extraction */ -set_current_state (TASK_INTERRUPTIBLE ); -schedule_timeout (HZ /2 ); - }else if (rc <0 ) { +msleep (500 ); +else if (rc <0 ) {dbg ("%s - error checking slots" , __FUNCTION__); thread_finished =1 ;break ;
@@ -568,11 +567,10 @@ poll_thread(void *data)while (controller->ops->query_enum ()) { rc =check_slots (); -if (rc >0 ) { +if (rc >0 )/* Give userspace a chance to handle extraction */ -set_current_state (TASK_INTERRUPTIBLE ); -schedule_timeout (HZ /2 ); - }else if (rc <0 ) { +msleep (500 ); +else if (rc <0 ) {dbg ("%s - error checking slots" , __FUNCTION__); thread_finished =1 ;break ;
@@ -595,8 +593,7 @@ poll_thread(void *data) } } -set_current_state (TASK_INTERRUPTIBLE ); -schedule_timeout (HZ /10 ); +msleep (100 ); }dbg ("poll thread signals exit" );up (&thread_exit);
_______________________________________________
Kernel-janitors mailing list
[email protected]
http://lists.osdl.org/mailman/listinfo/kernel-janitors