Skip to contentSkip to conversation

dptapps and Engine connect failed: COMPATIBILITY number

DISCUSSION Ray Van Dolson 1 participant 1 message Aug 25, 2004 MD RAID

lore
Share & tools
lore
#0 lore raw

This is somewhat related to my previous post. :-) I decided to try out the Adaptec Storage Manager utilities, even though they are from May 31, 2001 and seem to be for Red Hat 7.0/6.2 (the box I'm on is RH 8.0).

I installed the rpm with rpm -ivh --nodeps since it wanted the dptdrivers RPM, but the dpt_i2o driver was already installed on my system.

I started upt the dpt daemons -- no problems there. Also verified that the dpt_i2o driver was working:

[root@pop adaptec]# cat /proc/scsi/dpt_i2o/0
Adaptec I2O RAID Driver Version: 2.4 Build 5

Vendor: Adaptec Model: 2100S FW:370F
SCSI Host=scsi0 Control Node=/dev/dpti0 irq=11
post fifo size = 255
reply fifo size = 255
sg table size = 56

Devices:
ADAPTEC RAID-5 Rev: 370F
TID=519, (Channel=0, Target=0, Lun=0) (online)

Looks good so far, right? Now I try:

[root@pop adaptec]# /usr/dpt/raidutil -d 0 -L physical Engine connect failed: COMPATIBILITY number

:-(

Stumped here. Any suggestions? I tried without -d 0 and with -L array and simply got the same error. A google on the string brings up a few FreeBSD folks having the same issue which turned out to be shared memory related. No idea if this is the case on my system or not, or if it would even translate the same way between FreeBSD / Linux...