Skip to contentSkip to conversation

interrupt lockups & segfaults / custom hardware

DISCUSSION Paul Miller 1 participant 1 message Sep 1, 2004

lore
Share & tools
lore
#0 lore raw

I made a custom board that interfaces a Philips SJA1000 CAN controller to my PC's PCI bus. The device works fine until I start receiving lots of interrupts from received CAN messages, and the PC completely locks up. I'm sending 3 messages every 10ms from a DSP. It usually takes 10-60 seconds for a lockup on a 2.66GHz P4. Here are the details:

First, the chip's interrupt line is active low and remains low until it's interrupt vector is read. If Linux doesn't run my ISR immediately, the pin is remains low. Is this a problem? I'm wondering if Linux clears the PC interrupt and adds my ISR to a queue to be run. If so, I would expect Linux to be receiving thousands on interrupts before the interrupt is actually cleared. This may explain why I'm receiving thousands of interrupts that have a null interrupt vector (no interrupt source). Can I make the interrupt edge-triggered? I suspect I'll need to redesign my hardware.

Second, if I do not service the interrupt (return IRQ_NONE) I get a message in syslog that the interrupt occurred and was disabled because 'nobody cared', which is fine, but then a segfault appears in syslog. I suspect this is a bug in the kernel.

Aug 31 14:20:18 coecsl24 kernel: irq 17: nobody cared!
Aug 31 14:20:18 coecsl24 kernel:  [__report_bad_irq+42/139] 
__report_bad_irq+0x2
a/0x8b
Aug 31 14:20:18 coecsl24 kernel:  [note_interrupt+111/159] 
note_interrupt+0x6f/0
x9f
Aug 31 14:20:18 coecsl24 kernel:  [do_IRQ+295/310] do_IRQ+0x127/0x136
Aug 31 14:20:18 coecsl24 kernel:  [common_interrupt+24/32] 
common_interrupt+0x18
/0x20
Aug 31 14:20:18 coecsl24 kernel: handlers:
Aug 31 14:20:18 coecsl24 kernel: [__crc_mii_link_ok+376944/1089141] 
(snd_intel8x
0_interrupt+0x0/0x23c [snd_intel8x0])
Aug 31 14:20:18 coecsl24 kernel: Disabling IRQ #17

2.6.x Kernels, tested with 2.6.7 and 2.6.8.1..

Thanks!
-Paul