Skip to contentSkip to conversation

Patch for 3 ub bugs in 2.6.9-rc1-mm4

PATCH Applied Pete Zaitcev 2 participants 2 messages Sep 12, 2004 – Sep 14, 2004 Block layer

lore
Share & tools
lore
#0 lore raw

Hi, Greg,

Actual users of ub quickly found problems, so here's a patch to address some of them.

#1: An attempt to mount a CF card, pull the plug, then unmount causes a message "getblk: bad sector size 512" and an oops. This is caused by trying to do put_disk from disconnect instead of using a reference count. The sd.c does it this way (it uses kref).

#2: The hald fills /var/log/messages with block device errors. It seems that it happens because ub allowed opens of known offline devices, and then partition checking produced those errors. I hope taking code from sd.c should fix it.

Also I replaced usb_unlink_urb with usb_kill_urb.

-- Pete

drivers/block/ub.c +25 -18
diff -urp -X dontdiff linux-2.6.9-rc1-mm4/drivers/block/ub.c linux-2.6.9-rc1-mm4-ub/drivers/block/ub.c
@@ -490,6 +490,18 @@ static void ub_id_put(int id)
  */
 static void ub_cleanup(struct ub_dev *sc)
 {
+
+	/*
+	 * If we zero disk->private_data BEFORE put_disk, we have to check
+	 * for NULL all over the place in open, release, check_media and
+	 * revalidate, because the block level semaphore is well inside the
+	 * put_disk. But we cannot zero after the call, because *disk is gone.
+	 * The sd.c is blatantly racy in this area.
+	 */
+	/* disk->private_data = NULL; */
+	put_disk(sc->disk);
+	sc->disk = NULL;
+
 	ub_id_put(sc->id);
 	kfree(sc);
 }
@@ -1413,7 +1429,15 @@ static int ub_bd_open(struct inode *inod
 	if (sc->removable || sc->readonly)
 		check_disk_change(inode->i_bdev);
 
-	/* XXX sd.c and floppy.c bail on open if media is not present. */
+	/*
+	 * The sd.c considers ->media_present and ->changed not equivalent,
+	 * under some pretty murky conditions (a failure of READ CAPACITY).
+	 * We may need it one day.
+	 */
+	if (sc->removable && sc->changed && !(filp->f_flags & O_NDELAY)) {
+		rc = -ENOMEDIUM;
+		goto err_open;
+	}
 
 	if (sc->readonly && (filp->f_mode & FMODE_WRITE)) {
 		rc = -EROFS;
@@ -1498,8 +1522,11 @@ static int ub_bd_revalidate(struct gendi
 	printk(KERN_INFO "%s: device %u capacity nsec %ld bsize %u\n",
 	    sc->name, sc->dev->devnum, sc->capacity.nsec, sc->capacity.bsize);
 
+	/* XXX Support sector size switching like in sr.c */
+	// blk_queue_hardsect_size(q, sc->capacity.bsize);
 	set_capacity(disk, sc->capacity.nsec);
 	// set_disk_ro(sdkp->disk, sc->readonly);
+
 	return 0;
 }
 
@@ -1746,12 +1773,7 @@ static int ub_probe_clear_stall(struct u
 	wait_for_completion(&compl);
 
 	del_timer_sync(&timer);
-	/*
-	 * Most of the time, URB was done and dev set to NULL, and so
-	 * the unlink bounces out with ENODEV. We do not call usb_kill_urb
-	 * because we still think about a backport to 2.4.
-	 */
-	usb_unlink_urb(&sc->work_urb);
+	usb_kill_urb(&sc->work_urb);
 
 	/* reset the endpoint toggle */
 	usb_settoggle(sc->dev, endp, usb_pipeout(sc->last_pipe), 0);
@@ -2011,17 +2033,6 @@ static void ub_disconnect(struct usb_int
 		blk_cleanup_queue(q);
 
 	/*
-	 * If we zero disk->private_data BEFORE put_disk, we have to check
-	 * for NULL all over the place in open, release, check_media and
-	 * revalidate, because the block level semaphore is well inside the
-	 * put_disk. But we cannot zero after the call, because *disk is gone.
-	 * The sd.c is blatantly racy in this area.
-	 */
-	/* disk->private_data = NULL; */
-	put_disk(disk);
-	sc->disk = NULL;
-
-	/*
 	 * We really expect blk_cleanup_queue() to wait, so no amount
 	 * of paranoya is too much.
 	 *
Applied
#1 lore raw
Quoted 10 lines · Pete Zaitcev

Hi, Greg,

Actual users of ub quickly found problems, so here's a patch to address some of them.

#1: An attempt to mount a CF card, pull the plug, then unmount causes a message "getblk: bad sector size 512" and an oops. This is caused by trying to do put_disk from disconnect instead of using a reference count. The sd.c does it this way (it uses kref).

Quoted 6 lines

#2: The hald fills /var/log/messages with block device errors. It seems that it happens because ub allowed opens of known offline devices, and then partition checking produced those errors. I hope taking code from sd.c should fix it.

Also I replaced usb_unlink_urb with usb_kill_urb.

Applied, thanks.

(oops, you forgot the Signed-off-by: line...)

greg k-h