Skip to contentSkip to conversation

block/swim3: replace direct

PATCH New Nishanth Aravamudan 1 participant 1 message Sep 15, 2004

Subsystems (2)
Block layer Kernel janitors
lore
Share & tools
lore

Nishanth Aravamudan

author
#0 lore raw

PATCH 6/8 block/swim3: replace direct

Any comments would be appreciated.

Description: set_current_state() is used instead of direct assignment of current->state.

Signed-off-by Nishanth Aravamudan <[email protected]>
drivers/block/swim3.c +3 -3
@@ -832,7 +832,7 @@ static int fd_eject(struct floppy_state 
 			break;
 		}
 		swim3_select(fs, RELAX);
-		current->state = TASK_INTERRUPTIBLE;
+		set_current_state(TASK_INTERRUPTIBLE);
 		schedule_timeout(1);
 		if (swim3_readbit(fs, DISK_IN) == 0)
 			break;

@@ -900,7 +900,7 @@ static int floppy_open(struct inode *ino
 				break;
 			}
 			swim3_select(fs, RELAX);
-			current->state = TASK_INTERRUPTIBLE;
+			set_current_state(TASK_INTERRUPTIBLE);
 			schedule_timeout(1);
 		}
 		if (err == 0 && (swim3_readbit(fs, SEEK_COMPLETE) == 0

@@ -984,7 +984,7 @@ static int floppy_revalidate(struct gend
 		if (signal_pending(current))
 			break;
 		swim3_select(fs, RELAX);
-		current->state = TASK_INTERRUPTIBLE;
+		set_current_state(TASK_INTERRUPTIBLE);
 		schedule_timeout(1);
 	}
 	ret = swim3_readbit(fs, SEEK_COMPLETE) == 0

_______________________________________________
Kernel-janitors mailing list
[email protected]
http://lists.osdl.org/mailman/listinfo/kernel-janitors