firmware spelling errors
Subsystems (6)
PATCH 1/1 firmware spelling errors
The trivial patch by Tom Fredrik Blenning Klaussen below which fixes some mis-spelings of the word "firmware" still applies against 2.6.9-mm1.
Signed-off-by Adrian Bunk <[email protected]>
drivers/atm/fore200e.h renamed from usr/src/linux-2.6.8.1/drivers/atm/fore200e.h +1 -1
@@ -645,7 +645,7 @@typedef struct fw_header {u32 magic;/* magic number */ -u32 version;/* firware version id */ +u32 version;/* firmware version id */ u32 load_offset;/* fw load offset in board memory */ u32 start_offset;/* fw execution start address in board memory */ }fw_header_t ;
drivers/base/Kconfig renamed from usr/src/linux-2.6.8.1/drivers/base/Kconfig +1 -1
@@ -14,7 +14,7 @@ default y help Say yes to avoid building firmware. Firmware is usually shipped - with the driver, and only when updating the firware a rebuild + with the driver, and only when updating the firmware a rebuild should be made. If unsure say Y here.
drivers/net/wan/cosa.c renamed from usr/src/linux-2.6.8.1/drivers/net/wan/cosa.c +1 -1
@@ -156,7 +156,7 @@unsigned short startaddr;/* Firmware start address */ unsigned short busmaster;/* Use busmastering? */ int nchannels;/* # of channels on this card */ -int driver_status;/* For communicating with firware */ +int driver_status;/* For communicating with firmware */ int firmware_status;/* Downloaded, reseted, etc. */ long int rxbitmap, txbitmap;/* Bitmap of channels who are willing to send/receive data */ long int rxtx;/* RX or TX in progress? */
drivers/scsi/megaraid.c renamed from usr/src/linux-2.6.8.1/drivers/scsi/megaraid.c +1 -1
@@ -4006,7 +4006,7 @@ mbox->m_out.xferaddr = (u32 )adapter->buf_dma_handle;/* -* Non-ROMB firware fail this command, so all channels +* Non-ROMB firmware fail this command, so all channels * must be shown RAID */ adapter->mega_ch_class =0xFF ;