Skip to contentSkip to conversation

VIA Rhine WOL

DISCUSSION Roger Luethi 2 participants 2 messages Nov 18, 2004

lore
Share & tools
lore
#0 lore raw

I got quite a few reports regarding WOL and via-rhine. Here's some information so people can find it:

Rhine hardware can often do WOL without any support from the operating system, i.e. the hardware will wake-up upon receiving a magic packet even if you have no OS installed. That's meant for legacy OSes like DOS.

A WOL-aware OS has a more fine-grained control over Rhine WOL. For one, it can turn WOL off. It can also configure the type of events that will wake the system.

The via-rhine code has changed in the 2.6.9/2.6.10 time frame: Legacy WOL is turned off (mostly), so it will not work unless you explicitly tell the driver to enable WOL. You can do this using ethtool(8).

If WOL used to work with your Rhine hardware and now all of a sudden doesn't, check first if you enabled WOL using ethtool.

Roger

#1 lore raw
Quoted 8 lines · Roger Luethi

The via-rhine code has changed in the 2.6.9/2.6.10 time frame: Legacy WOL is turned off (mostly), so it will not work unless you explicitly tell the driver to enable WOL. You can do this using ethtool(8).

If WOL used to work with your Rhine hardware and now all of a sudden doesn't, check first if you enabled WOL using ethtool.

Roger

That was the information I needed... :o)
I just wondered why my machine did not want to wake up.

Sven

Signature · 2 lines
Sven Ladegast, Friedrich-Fröbel-Straße 11, 93310 Arnstadt / Germany
Phone: +49-175-5334308, PGP-key: 0x5856A5ED