Skip to contentSkip to conversation

2.6.10rc3: swarm only configures eth0, not eth1

DISCUSSION Martin Michlmayr 1 participant 1 message Dec 23, 2004 MIPS

lore
Share & tools
lore
#0 lore raw

I just booted a 2.6.10rc3 kernel on my SWARM and noticed that only eth0 is configured, but eth1 isn't (even though I booted via eth1):

sbmac: configuring MAC at 10064000
eth0: enabling TCP rcv checksum
eth0: SiByte Ethernet at 0x10064000, address: 00:02:4C:FE:0D:08
sbmac: not configuring MAC at 10066000

On a 2.4.x kernel, both network interfaces are configured and I get:

eth0: SiByte Ethernet at 0x10064000, address: 00-02-4C-FE-0D-08
eth0: enabling TCP rcv checksum
eth1: SiByte Ethernet at 0x10065000, address: 00-02-4C-FE-0D-09
eth1: enabling TCP rcv checksum

Note the difference for eth1 between 10066000 (2.6) and 10065000 (2.4).

Thiemo suggested that this might be because the 2.4 kernel is 32 bit while the 2.6 kernel is 64 bit and that 2.6 might get the address wrong.

Signature · 2 lines
Martin Michlmayr
http://www.cyrius.com/