Skip to contentSkip to conversation

pcf8591 boot time parameters

DISCUSSION Karel Kulhavy 2 participants 2 messages Dec 27, 2004 – Dec 31, 2004

lore
Share & tools
lore
#0 lore raw

Is it possible to configure pcf8591 driver using boot time commandline parameters?

If yes, where are they described? I didn't find it. (<Help> doesn't say anything). also /linux-2.6.10/Documentation/i2c$ fgrep PCF * didn't reveal anything related.

I only found documentation for module parameters by means of modinfo pcf8591

Cl<

#1 lore raw
Quoted 8 lines · Karel Kulhavy

Is it possible to configure pcf8591 driver using boot time commandline parameters?

If yes, where are they described? I didn't find it. (<Help> doesn't say anything). also /linux-2.6.10/Documentation/i2c$ fgrep PCF * didn't reveal anything related.

I only found documentation for module parameters by means of modinfo pcf8591

and what did it tell you? I see (when built as a loadable module,\
but they are still valid when built in-kernel):

parm:           force:List of adapter,address pairs to boldly assume to be present
parm:           force_pcf8591:List of adapter,address pairs which are unquestionably assumed to contain a `pcf8591' chip
parm:           probe:List of adapter,address pairs to scan additionally
parm:           ignore:List of adapter,address pairs not to scan
parm:           input_mode:Analog input mode:

0 = four single ended inputs
1 = three differential inputs
2 = single ended and differential mixed
3 = two differential inputs

It seems that there is a list of i2c client parameters in Documentation/i2c/writing-clients .

I don't know i2c, but any driver that #includes
linux/i2c.h has defined for it these parameters:
probe, probe_range
ignore, ignore_range
force

and any driver that #includes linux/i2c-sensor.h
has defined for it these parameters:
force_<driver_basename>
probe
ignore
force

but it would be better for someone who is familiar with those twisted macros to document all of this.

Signature · 1 line
~Randy