Flash Burst Mode
Hi People :)
At the moment I am trying to get the burst read mode of my flash chips running. I have a Motorola i-MX CPU with ARM9 core. The Flash device is a 28F128K18: "Intel StrataFlash(R) Synchronous Memory".
If I understood right I tell the flash device with some commands and data register words delivered by address bus to work in sync mode. After that I program the chip select control signal of the microcontroller to enable burst modus.
I am doing that by hand with the u-boot CLI but I manage to read garbage after enabling the burst mode only.
Does anybody have made such a setup working? Or is there one board in the u-boot source tree make use of flash burst mode so I can put this into i.MX arch also?
Kind Regards, Konsti
Signature · 2 lines
GPG KeyID EF62FCEF Fingerprint: 13C9 B16B 9844 EC15 CC2E A080 1E69 3FDA EF62 FCEF