intel8x0: no sound in 2.6.11 rc3 & 4 (fine with 2.6.10)
Hello
I have read a post in lkml.org that states that the problem experienced in rc3 has gone (1). That is not the case for me.
My audio device is
0000:00:1f.5 Multimedia audio controller: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) AC'97 Audio Controller (rev 01)
Subsystem: IBM: Unknown device 0554
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0
Interrupt: pin B routed to IRQ 11
Region 0: I/O ports at 1c00 [size=256]
Region 1: I/O ports at 18c0 [size=64]
Region 2: Memory at d0100c00 (32-bit, non-prefetchable) [size=512]
Region 3: Memory at d0100800 (32-bit, non-prefetchable) [size=256]
Capabilities: [50] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
In 2.6.10 and in 2.6.11-rc3 & 4 the clock is set to 48khz.
eg:
intel8x0_measure_ac97_clock: measured 49502 usecs
intel8x0: clocking to 48000
It uses an Analog Devices AD1981B
I have put a tar file of the /proc/asound directory of 2.6.10 and 2.6.11-rc4 in
http://pusa.uv.es/~ulisses/asound-intel8x0/
the tar files were done while playing pcm audio, (not being eard in rc4).
I have found that I had to Mute __both__ "Headphone Jack Sense" and "Line Jack Sense" in order to ear the audio in rc4.
Please let me know if you need further info or you want a tester
All this is on a IBM Thinkpad R51 - Type 2887 -AVG
(tot toc: IBM, we're buying your laptops too)
Thanks in advance
Ulisses
(1) http://lkml.org/lkml/2005/2/18/93
Signature · 7 lines
Debian GNU/Linux: a dream come true ----------------------------------------------------------------------------- "Computers are useless. They can only give answers." Pablo Picasso "Debugging is twice as hard as writing the code in the first place. Therefore, if you write the code as cleverly as possible, you are, by definition, not smart enough to debug it." - Brian W. Kernighan
Please cc: alsa-devel when reporting ALSA issues.
Lee
Quoted 43 lines · On Sat, 2005-02-19 at 13:11 +0100, [email protected] wrote:
Hello
I have read a post in lkml.org that states that the problem experienced in rc3 has gone (1). That is not the case for me.
My audio device is
0000:00:1f.5 Multimedia audio controller: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) AC'97 Audio Controller (rev 01)
Subsystem: IBM: Unknown device 0554
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0
Interrupt: pin B routed to IRQ 11
Region 0: I/O ports at 1c00 [size=256]
Region 1: I/O ports at 18c0 [size=64]
Region 2: Memory atd0100c00(32-bit, non-prefetchable) [size=512]
Region 3: Memory atd0100800(32-bit, non-prefetchable) [size=256]
Capabilities: [50] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mAPME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-In 2.6.10 and in 2.6.11-rc3 & 4 the clock is set to 48khz.
eg:
intel8x0_measure_ac97_clock: measured 49502 usecs
intel8x0: clocking to 48000It uses an Analog Devices AD1981B
I have put a tar file of the
/proc/asounddirectory of 2.6.10 and 2.6.11-rc4 inhttp://pusa.uv.es/~ulisses/asound-intel8x0/the tar files were done while playing pcm audio, (not being eard in rc4).
I have found that I had to Mute
__both__"Headphone Jack Sense" and "Line Jack Sense" in order to ear the audio in rc4.Please let me know if you need further info or you want a tester
All this is on a IBM Thinkpad R51 - Type 2887 -AVG
Quoted 7 lines
(tot toc: IBM, we're buying your laptops too)
Thanks in advance
Ulisses
-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users. Discover which products truly live up to the hype. Start reading now.
http://ads.osdn.com/?ad_id=6595&alloc_id=14396&op=click
At Sat, 19 Feb 2005 13:11:57 +0100,
Quoted 31 lines · [email protected] wrote:
Hello
I have read a post in lkml.org that states that the problem experienced in rc3 has gone (1). That is not the case for me.
My audio device is
0000:00:1f.5 Multimedia audio controller: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) AC'97 Audio Controller (rev 01)
Subsystem: IBM: Unknown device 0554
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0
Interrupt: pin B routed to IRQ 11
Region 0: I/O ports at 1c00 [size=256]
Region 1: I/O ports at 18c0 [size=64]
Region 2: Memory atd0100c00(32-bit, non-prefetchable) [size=512]
Region 3: Memory atd0100800(32-bit, non-prefetchable) [size=256]
Capabilities: [50] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mAPME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-In 2.6.10 and in 2.6.11-rc3 & 4 the clock is set to 48khz.
eg:
intel8x0_measure_ac97_clock: measured 49502 usecs
intel8x0: clocking to 48000It uses an Analog Devices AD1981B
Quoted 8 lines
I have put a tar file of the
/proc/asounddirectory of 2.6.10 and 2.6.11-rc4 inhttp://pusa.uv.es/~ulisses/asound-intel8x0/the tar files were done while playing pcm audio, (not being eard in rc4).
I have found that I had to Mute
__both__"Headphone Jack Sense" and "Line Jack Sense" in order to ear the audio in rc4.
Yes, that's correct -> Problem solved?
The patch to correct these states as default wasn't merged to 2.6.11.
Takashi
Quoted 30 lines · [email protected] wrote:
Hello
I have read a post in lkml.org that states that the problem experienced in rc3 has gone (1). That is not the case for me.
My audio device is
0000:00:1f.5 Multimedia audio controller: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) AC'97 Audio Controller (rev 01)
Subsystem: IBM: Unknown device 0554
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0
Interrupt: pin B routed to IRQ 11
Region 0: I/O ports at 1c00 [size=256]
Region 1: I/O ports at 18c0 [size=64]
Region 2: Memory atd0100c00(32-bit, non-prefetchable) [size=512]
Region 3: Memory atd0100800(32-bit, non-prefetchable) [size=256]
Capabilities: [50] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mAPME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-In 2.6.10 and in 2.6.11-rc3 & 4 the clock is set to 48khz.
eg:
intel8x0_measure_ac97_clock: measured 49502 usecs
intel8x0: clocking to 48000It uses an Analog Devices AD1981B
Quoted 8 lines
I have put a tar file of the
/proc/asounddirectory of 2.6.10 and 2.6.11-rc4 inhttp://pusa.uv.es/~ulisses/asound-intel8x0/the tar files were done while playing pcm audio, (not being eard in rc4).
I have found that I had to Mute
__both__"Headphone Jack Sense" and "Line Jack Sense" in order to ear the audio in rc4.
I keep seeing this advice, but what tool do you use to mute them? I don't see anything like that in alsamixer, aumix, or any other program I tried.
Quoted 4 lines
Please let me know if you need further info or you want a tester
All this is on a IBM Thinkpad R51 - Type 2887 -AVG
ASUS 1681 - same symptoms.
Signature · 3 lines
-bill davidsen ([email protected]) "The secret to procrastination is to put things off until the last possible moment - but no longer" -me
Quoted 9 lines · Bill Davidsen
Quoted 8 lines · [email protected] wrote:
Hello
I have read a post in lkml.org that states that the problem experienced in rc3 has gone (1). That is not the case for me.
My audio device is
0000:00:1f.5 Multimedia audio controller: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) AC'97 Audio Controller (rev 01)
<snip>
Quoted 6 lines
Quoted 2 lines
I have found that I had to Mute
__both__"Headphone Jack Sense" and "Line Jack Sense" in order to ear the audio in rc4.I keep seeing this advice, but what tool do you use to mute them? I don't see anything like that in alsamixer, aumix, or any other program I tried.
I have a T41p with: Multimedia audio controller: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) AC'97 Audio Controller (rev 01), which looks to the be the same as Ulisses' device.
It works fine for me in 2.6.11-rc4 (has worked fine for a while, as well). I have both a "Headphone Jack Sense" and "Line Jack Sense" (both set to off) mixer entry in alsamixer. I'm not sure why you're not seeing these entries...
Thanks,
Nish