Skip to contentSkip to conversation

block/swim3: replace direct assignment with set_current_state()

PATCH In review [email protected] 1 participant 1 message Mar 5, 2005 Block layer

lore
Share & tools
lore

[email protected]

author
#0 lore raw

PATCH 3/15 block/swim3: replace direct assignment with set_current_state()

Any comments would be appreciated.

set_current_state() is used instead of direct assignment of current->state.

Signed-off-by Nishanth Aravamudan <[email protected]>
Signed-off-by Maximilian Attems <[email protected]>
Signed-off-by Domen Puncer <[email protected]>

---

 kj-domen/drivers/block/swim3.c |    6 +++---
 1 files changed, 3 insertions(+), 3 deletions(-)
drivers/block/swim3.c renamed from drivers/block/swim3.c~set_current_state-drivers_block_swim3 +3 -3
diff -puN drivers/block/swim3.c~set_current_state-drivers_block_swim3 drivers/block/swim3.c
@@ -832,7 +832,7 @@ static int fd_eject(struct floppy_state 
 			break;
 		}
 		swim3_select(fs, RELAX);
-		current->state = TASK_INTERRUPTIBLE;
+		set_current_state(TASK_INTERRUPTIBLE);
 		schedule_timeout(1);
 		if (swim3_readbit(fs, DISK_IN) == 0)
 			break;

@@ -900,7 +900,7 @@ static int floppy_open(struct inode *ino
 				break;
 			}
 			swim3_select(fs, RELAX);
-			current->state = TASK_INTERRUPTIBLE;
+			set_current_state(TASK_INTERRUPTIBLE);
 			schedule_timeout(1);
 		}
 		if (err == 0 && (swim3_readbit(fs, SEEK_COMPLETE) == 0

@@ -984,7 +984,7 @@ static int floppy_revalidate(struct gend
 		if (signal_pending(current))
 			break;
 		swim3_select(fs, RELAX);
-		current->state = TASK_INTERRUPTIBLE;
+		set_current_state(TASK_INTERRUPTIBLE);
 		schedule_timeout(1);
 	}
 	ret = swim3_readbit(fs, SEEK_COMPLETE) == 0

_