Skip to contentSkip to conversation

connecting BDI2000 to ML403

DISCUSSION Peter 'p2' De Schrijver 3 participants 3 messages Apr 28, 2005

lore
Share & tools
lore
#0 lore raw

Hi,

I'm trying to figure out how to connect the BDI 2000 with a Xilinx ML403 development board. As far as I can see in the ML403 schematics, the JTAG connector lacks the nTRST and the HALT signals needed for JTAG debugging. Any ideas ?

Thanks,

Peter (p2).

#1 lore raw
Quoted 10 lines

Hi,

I'm trying to figure out how to connect the BDI 2000 with a Xilinx ML403 development board. As far as I can see in the ML403 schematics, the JTAG connector lacks the nTRST and the HALT signals needed for JTAG debugging. Any ideas ?

Thanks,

Peter (p2).

The BDI doesn't need nTRST or HALT, so that's not your problem. nTRST must be pulled high, but the BDI doesn't need to drive that signal.

Mark Chambers

#2 lore raw
In reply to Peter 'p2' De Schrijver

If your debugger needs nTRST and HALT you can route the JTAG signals of the PPC405 processor through user IO pins to the expansion connector.

- Peter

Quoted 18 lines · Peter 'p2' De Schrijver wrote:

Hi,

I'm trying to figure out how to connect the BDI 2000 with a Xilinx ML403 development board. As far as I can see in the ML403 schematics, the JTAG connector lacks the nTRST and the HALT signals needed for JTAG
debugging. Any ideas ?

Thanks,

Peter (p2).

------------------------------------------------------------------------

_______________________________________________
Linuxppc-embedded mailing list
[email protected]
https://ozlabs.org/mailman/listinfo/linuxppc-embedded