(no subject)
When I fire up the board,the U-boot reports are as follows:
********************************************************
U-Boot 1.1.2 (May 10 2005 - 08:54:34)
CPU: MPC5200 v1.2 at 396 MHz
Bus 132 MHz, IPB 66 MHz, PCI 33 MHz Board: Motorola MPC5200 (IceCube) I2C: 85 kHz, ready DRAM: 32 MB FLASH: 0 kB
*** Warning - bad CRC, using default environment
PCI: Bus Dev VenId DevId Class Int
00 1a 1057 5803 0680 00 In: serial Out: serial Err: serial Net: FEC ETHERNET IDE: Bus 0: ............................................................** Tim
eout **
Type "run flash_nfs" to mount root filesystem over NFS
Hit any key to stop autoboot: 0
=>
**********************************************************
Is it ok? What's the problem on "FLASH: 0 kB
*** Warning - bad CRC, using default environment "?
It can not find my flash on board?
Best Regards
zhonglei
Quoted 1 line · In message <[email protected]> you wrote:
When I fire up the board,the U-boot reports are as follows:
...
Quoted 8 lines
U-Boot 1.1.2 (May 10 2005 - 08:54:34)
CPU: MPC5200 v1.2 at 396 MHz
Bus 132 MHz, IPB 66 MHz, PCI 33 MHz Board: Motorola MPC5200 (IceCube) I2C: 85 kHz, ready DRAM: 32 MB FLASH: 0 kB
^^^^^^^^^^^^^^
Problem here
Quoted 4 lines
**********************************************************
Is it ok? What's the problem on "FLASH: 0 kB
*** Warning - bad CRC, using default environment "?
It can not find my flash on board?
Correct. Seems you don't have an IceCube (aka Lite5200) board. You will have to port U-Boot to your hartware.
Best regards,
Wolfgang Denk
Signature · 5 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de ... bacteriological warfare ... hard to believe we were once foolish enough to play around with that. -- McCoy, "The Omega Glory", stardate unknown