Skip to contentSkip to conversation

2.6 block immediate write

DISCUSSION NZG 1 participant 1 message May 26, 2005

lore
Share & tools
lore

NZG

author
#0 lore raw

I'm developing a generic MMC driver using SPI protocol for the 2.6 kernel.

I want this device to be compatible with uClinux distributions, so I need to be able to set up the request queue so that writes to the device happen immediately, rather than delaying until they "have to" happen, such as on an umount.

1. is this possible?
2. can anyone point me towards some good documentation as to the correct way to set up the queue?

I've gone through ldd3, but it seems a little ambiguous on this point.

I hope this is a valid question for the vger list. I think it is, but I'm a bit new to it.

thx,
NZG.