Skip to contentSkip to conversation

Problems with iproute2

LARTC Jan Andersen 2 participants 2 messages Jul 9, 2005 – Jul 10, 2005

lore
Share & tools
lore
#0 lore raw

I'm using Debian (sarge)

I do now have 2 ISP, one DSL and one cabel.

I want to use the DSL as my primary and only use the cabel-modem if the DSL fails.

The setup is:

IP1 -> Router -> NAT_IP1 -> eth0 -> eth2 (LAN)
IP2 -> Cable-Modem -> eth1 -> eth2 (LAN)

I wrote the following in my /etc/iproute2/rt_tables

ip rule add from NAT_IP1 lookup 1
ip route add 10.1.0.0/16 via 10.1.1.1 table 1 ip route add 0/0 via NAT_IP1 table 1

ip rule add from IP2 lookup 2
ip route add 10.1.0.0/16 via 10.1.1.1 table 2 ip route add 0/0 via IP2 table 2

The problem is identical to http://www.samag.com/documents/s24/sam0201h/

But if I write "ip rule list" I get the following error:

Database /etc/iproute2/rt_tables is corrupted at ip rule add from 192.168.100.254 lookup 1

Does anyone know and have a solution to this problem?

Regards

Jan Andersen

_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc

#1 lore raw
Quoted 27 lines · Jan Andersen

I'm using Debian (sarge)

I do now have 2 ISP, one DSL and one cabel.

I want to use the DSL as my primary and only use the cabel-modem if the DSL fails.

The setup is:

IP1 -> Router -> NAT_IP1 -> eth0 -> eth2 (LAN)
IP2 -> Cable-Modem -> eth1 -> eth2 (LAN)

I wrote the following in my /etc/iproute2/rt_tables

ip rule add from NAT_IP1 lookup 1
ip route add 10.1.0.0/16 via 10.1.1.1 table 1 ip route add 0/0 via NAT_IP1 table 1

ip rule add from IP2 lookup 2
ip route add 10.1.0.0/16 via 10.1.1.1 table 2 ip route add 0/0 via IP2 table 2

The problem is identical to http://www.samag.com/documents/s24/sam0201h/

But if I write "ip rule list" I get the following error:

Quoted 8 lines

Database /etc/iproute2/rt_tables is corrupted at ip rule add from 192.168.100.254 lookup 1

Does anyone know and have a solution to this problem?

Regards

Jan Andersen

No, I don't have a solution. What is in your /etc/iproute2/rt_tables file?

Normally, everything should be commented except
255 local
254 main
253 default
0 unspec

Are you sure 'route add' should work when both routes are identical?

Where does the 192.168.100.254 come from?

Why allow NAT of the internet IPs?
OPINION 1: One NAT is plenty, two is begging trouble.
OPINION 2: Most of the problems reported here have "example.com" ip addresses, so avoiding NAT is A Good Thing.
--
gypsy
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc