Skip to contentSkip to conversation

saa7134 card no longer working

DISCUSSION Adrian Bunk 1 participant 2 messages Jul 10, 2005 – Jul 12, 2005

lore
Share & tools
lore
#0 lore raw

Hi,

I observed the following problem with a Tevion MD 9717 card:

It works in 2.6.12-rc6-mm1, but AFAIR this was the last kernel where it worked, in more recent kernels (including 2.6.13-rc2-mm1) tvtime only says "no signal".

dmesg output with 2.6.12-rc6-mm1:
saa7134[0]: found at 0000:00:0a.0, rev: 1, irq: 6, latency: 32, mmio: 0xcfffcc00 saa7134[0]: subsystem: 1131:0000, board: Tevion MD 9717 [card=6,insmod option] saa7134[0]: board init: gpio is 100a0
saa7134[0]: Huh, no eeprom present (err=-5)?
saa7134[0]: registered device video0 [v4l2]
saa7134[0]: registered device vbi0
saa7134[0]: registered device radio0
tuner 4-0060: chip found @ 0xc0 (saa7134[0])
tuner 4-0060: type set to 5 (Philips PAL_BG (FI1216 and compatibles))

In 2.6.13-rc2-mm1 there's an additional line tuner 4-0060: All bytes are equal. It is not a TEA5767

I'm always saying "saa7134.card=6" at the kernel command line since I got a "no eeprom present" message from the driver without this.

The card is working with 2.6.12-rc6-mm1, but during running, I occasionally get the following message in the syslog:
saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [last detected]

cu
Adrian

Signature · 4 lines
       "Is there not promise of rain?" Ling Tan asked suddenly out
        of the darkness. There had been need of rain for many days.
       "Only a promise," Lao Er said.
                                       Pearl S. Buck - Dragon Seed
#1 lore raw

FYI:
This problem is fixed in 2.6.13-rc2-mm2.

Quoted 31 lines · Adrian Bunk

Hi,

I observed the following problem with a Tevion MD 9717 card:

It works in 2.6.12-rc6-mm1, but AFAIR this was the last kernel where it worked, in more recent kernels (including 2.6.13-rc2-mm1) tvtime only says "no signal".

dmesg output with 2.6.12-rc6-mm1:
saa7134[0]: found at 0000:00:0a.0, rev: 1, irq: 6, latency: 32, mmio: 0xcfffcc00 saa7134[0]: subsystem: 1131:0000, board: Tevion MD 9717 [card=6,insmod option] saa7134[0]: board init: gpio is 100a0
saa7134[0]: Huh, no eeprom present (err=-5)?
saa7134[0]: registered device video0 [v4l2]
saa7134[0]: registered device vbi0
saa7134[0]: registered device radio0
tuner 4-0060: chip found @ 0xc0 (saa7134[0])
tuner 4-0060: type set to 5 (Philips PAL_BG (FI1216 and compatibles))

In 2.6.13-rc2-mm1 there's an additional line tuner 4-0060: All bytes are equal. It is not a TEA5767

I'm always saying "saa7134.card=6" at the kernel command line since I got a "no eeprom present" message from the driver without this.

The card is working with 2.6.12-rc6-mm1, but during running, I occasionally get the following message in the syslog:
saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [last detected]

cu
Adrian