UCB1400 pxa2xx-ac97 failed with error -13 on PXA2xx
A message that is not in the archive (sent off-list or not yet received): [email protected]
Hi,
I am facing the following problem with ALSA and UCB1400 codec on Colibri PXA270. After having applied Nicolas patches and platform entries in colibri.c, I get the following boot up error messages which annoys me a lot.
.........
ts: UCB1x00 touchscreen protocol output
ts: Compaq touchscreen protocol output
Colibri MMC/SD setup done.
Advanced Linux Sound Architecture Driver Version 1.0.9rc2 (Thu Mar 24 10:33:39 2005 UTC).pxa2xx_ac97_reset: cold reset timeout (GSR=0x0)pxa2xx_ac97_reset: warm reset timeout (GSR=0x0)pxa2xx_ac97_read: CAR_CAIP already setpxa2xx_ac97_write: CAR_CAIP already setpxa2xx_ac97_read: CAR_CAIP already setpxa2xx_ac97_read: CAR_CAIP already set
ALSA sound/pci/ac97/ac97_codec.c:1932: AC'97 0 access error (not audio or modem codec)
pxa2xx-ac97: probe of pxa2xx-ac97 failed with error -13
ALSA device list:
No soundcards found.
.....
Can anyone tell me what went wrong and here's the kernel config which I use similar to the previous posts by Takács Áron.
#
# Sound
#CONFIG_SOUND=y
#
# Advanced Linux Sound Architecture
#CONFIG_SND=yCONFIG_SND_TIMER=yCONFIG_SND_PCM=y
# CONFIG_SND_SEQUENCER is not setCONFIG_SND_OSSEMUL=yCONFIG_SND_MIXER_OSS=yCONFIG_SND_PCM_OSS=yCONFIG_SND_VERBOSE_PRINTK=yCONFIG_SND_DEBUG=y
# CONFIG_SND_DEBUG_MEMORY is not set
# CONFIG_SND_DEBUG_DETECT is not set
#
# Generic devices
#
# CONFIG_SND_DUMMY is not set
# CONFIG_SND_MTPAV is not set
# CONFIG_SND_SERIAL_U16550 is not set
# CONFIG_SND_MPU401 is not setCONFIG_SND_AC97_CODEC=y
#
# ALSA ARM devices
#
CONFIG_SND_PXA2xx_AC97=y
CONFIG_SND_PXA2xx_PCM=y
and made the following changes in the colibri.c for platform entries
static struct platform_device ucb1400_audio_device = {
.name = "pxa2xx-ac97",
.id = -1,
};
static struct platform_device *devices[] __initdata = {
#ifdef CONFIG_DM9000
&dm9000_device,
#endif
&ucb1400_audio_device,
}; It would be garteful, if anyone could help me to fix these issues. Thanks
Sara
--
This message was sent on behalf of [email protected] at openSubscriber.com
http://www.opensubscriber.com/message/[email protected]/1825733.html
Quoted 7 lines · On Fri, 2006-10-27 at 23:50 +0800, [email protected] wrote:
Hi,
I am facing the following problem with ALSA and UCB1400 codec on Colibri PXA270. After having applied Nicolas patches and platform entries incolibri.c, I get the following boot up error messages which annoys me a lot.
.........
ts: UCB1x00 touchscreen protocol output
ts: Compaq touchscreen protocol output
Colibri MMC/SD setup done.
Advanced Linux Sound Architecture Driver Version 1.0.9rc2 (Thu Mar 24 10:33:39 2005 UTC).
Way too old to debug. Try the latest kernel release.
Lee