Add ACPI based P-state support
PATCH 1/1 Add ACPI based P-state support
Patch to support P-state transitions on ia64. This driver is based on ACPI, and uses the ACPI processor driver interface to find out the P-state support information for the processor. This driver plugs into generic cpufreq infrastructure.
Once this driver is loaded successfully, ondemand/userspace governor can be used to change the CPU frequency dynamically based on load or on request from userspace process.
Refer :
ACPI specification -
http://www.acpi.info
P-state related PAL calls -
http://developer.intel.com/design/itanium/downloads/24869909.pdf
Signed-off-by Venkatesh Pallipadi <[email protected]>
arch/ia64/Kconfig +6 -0
@@ -390,6 +390,12 @@ source "drivers/acpi/Kconfig" endif +if PM + +source "arch/ia64/kernel/cpufreq/Kconfig" + +endif + endmenu if !IA64_HP_SIM
arch/ia64/kernel/cpufreq/acpi-cpufreq.c +495 -0
495 lines not on this page · raw message
arch/ia64/kernel/cpufreq/Kconfig +29 -0
@@ -0,0 +1,29 @@ + +# +# CPU Frequency scaling +# + +menu "CPU Frequency scaling" + +source "drivers/cpufreq/Kconfig" + +if CPU_FREQ + +comment "CPUFreq processor drivers" + +config IA64_ACPI_CPUFREQ + tristate "ACPI Processor P-States driver" + select CPU_FREQ_TABLE + depends on ACPI_PROCESSOR + help + This driver adds a CPUFreq driver which utilizes the ACPI + Processor Performance States. + + For details, take a look at <file:Documentation/cpu-freq/>. + + If in doubt, say N. + +endif # CPU_FREQ + +endmenu +
arch/ia64/kernel/cpufreq/Makefile +1 -0
@@ -0,0 +1 @@ +obj-$(CONFIG_IA64_ACPI_CPUFREQ) += acpi-cpufreq.o
arch/ia64/kernel/Makefile +1 -0
@@ -20,6 +20,7 @@ obj-$(CONFIG_SMP) += smp.o smpboot.o do obj-$(CONFIG_NUMA) += numa.o obj-$(CONFIG_PERFMON) += perfmon_default_smpl.o obj-$(CONFIG_IA64_CYCLONE) += cyclone.o +obj-$(CONFIG_CPU_FREQ) += cpufreq/ obj-$(CONFIG_IA64_MCA_RECOVERY) += mca_recovery.o obj-$(CONFIG_KPROBES) += kprobes.o jprobes.o obj-$(CONFIG_IA64_UNCACHED_ALLOCATOR) += uncached.o
include/asm-ia64/acpi.h +5 -0
@@ -116,6 +116,11 @@ extern int __initdata nid_to_pxm_map[MAXextern u16 ia64_acpiid_to_sapicid[]; +/* +* Refer Intel ACPI _PDC support document for bit definitions +*/ +#define ACPI_PDC_EST_CAPABILITY_SMP 0x8 +#endif /*__KERNEL__*/ #endif /*_ASM_ACPI_H*/
include/asm-ia64/pal.h +21 -0
@@ -75,6 +75,8 @@#define PAL_CACHE_READ 259/* read tag & data of cacheline for diagnostic testing */ #define PAL_CACHE_WRITE 260/* write tag & data of cacheline for diagnostic testing */ #define PAL_VM_TR_READ 261/* read contents of translation register */ +#define PAL_GET_PSTATE 262/* get the current P-state */ +#define PAL_SET_PSTATE 263/* set the P-state */ #ifndef __ASSEMBLY__
@@ -1111,6 +1113,25 @@ ia64_pal_halt_info (pal_power_mgmt_info_return iprv.status; } +/* Get the current P-state information */ +static inline s64 +ia64_pal_get_pstate (u64 *pstate_index) +{ +struct ia64_pal_retval iprv; +PAL_CALL_STK (iprv,PAL_GET_PSTATE ,0 ,0 ,0 ); + *pstate_index = iprv.v0; +return iprv.status; +} + +/* Set the P-state */ +static inline s64 +ia64_pal_set_pstate (u64 pstate_index) +{ +struct ia64_pal_retval iprv; +PAL_CALL_STK (iprv,PAL_SET_PSTATE , pstate_index,0 ,0 ); +return iprv.status; +} +/* Cause the processor to enter LIGHT HALT state, where prefetching and execution are * suspended, but cache and TLB coherency is maintained. */