Skip to contentSkip to conversation

remove a redundant variable in sys_prctl()

PATHC Jesper Juhl 1 participant 1 message Aug 21, 2005

lore
Share & tools
lore
#0 lore raw

Here's a re-send of a small patch I sent on Aug. 9.

The patch removes a redundant variable `sig' from sys_prctl().

For some reason, when sys_prctl is called with option == PR_SET_PDEATHSIG then the value of arg2 is assigned to an int variable named sig. Then sig is tested with valid_signal() and later used to set the value of current->pdeath_signal .
There is no reason to use this intermediate variable since valid_signal() takes a unsigned long argument, so it can handle being passed arg2 directly, and if the call to valid_signal is OK, then we know the value of arg2 is in the range zero to _NSIG and thus it'll easily fit in a plain int and thus there's no problem assigning it later to current->pdeath_signal (which is an int).

The patch gets rid of the pointless variable `sig'.
This reduces the size of kernel/sys.o in 2.6.13-rc6-mm1 by 32 bytes on my system.

Patch has been compile tested, boot tested, and just to make damn sure I didn't break anything I wrote a quick test app that calls prctl(PR_SET_PDEATHSIG ...) with the entire range of values for a unsigned long, and it behaves as expected with and without the patch.

---

 kernel/sys.c |    6 ++----
 1 files changed, 2 insertions(+), 4 deletions(-)
kernel/sys.c +2 -4
@@ -1709,7 +1709,6 @@ asmlinkage long sys_prctl(int option, un
 			  unsigned long arg4, unsigned long arg5)
 {
 	long error;
-	int sig;
 
 	error = security_task_prctl(option, arg2, arg3, arg4, arg5);
 	if (error)
@@ -1717,12 +1716,11 @@ asmlinkage long sys_prctl(int option, un
 
 	switch (option) {
 		case PR_SET_PDEATHSIG:
-			sig = arg2;
-			if (!valid_signal(sig)) {
+			if (!valid_signal(arg2)) {
 				error = -EINVAL;
 				break;
 			}
-			current->pdeath_signal = sig;
+			current->pdeath_signal = arg2;
 			break;
 		case PR_GET_PDEATHSIG:
 			error = put_user(current->pdeath_signal, (int __user *)arg2);