ioc4_serial: Remove bogus error message
PATCH 1/1 ioc4_serial: Remove bogus error message
This change removes a bogus error message from the IOC4 serial driver interrupt handler.
This error message is bogus for two reasons. First, it can never occur given that current code takes care to initialize IOC4 in such a way that
these "unknown" interrupts could never occur. Second, this code fails
to take into account that other drivers can share the IOC4 interrupt mechanism through SA_SHIRQ, and thus this driver is not in-fact "all-knowing".
Finally, this error message triggers every time some "unknown" interrupt occurs -- it's not rate limited or repetition limited in any way, thereby effectively denying use of the console device. Given its bogosity in the first place, it's best to just get rid of it entirely.
ioc4_serial.c | 12 ------------ 1 files changed, 12 deletions(-)
drivers/serial/ioc4_serial.c +0 -12
@@ -973,18 +973,6 @@ static irqreturn_t ioc4_intr(int irq, vo this_ir &= ~this_mir; } } -if (this_ir) { -printk (KERN_ERR -"unknown IOC4 %s interrupt 0x%x, sio_ir = 0x%x," -" sio_ies = 0x%x, other_ir = 0x%x :" -"other_ies = 0x%x\n" , - (intr_type ==IOC4_SIO_INTR_TYPE ) ?"sio" : -"other" , this_ir, -readl (&soft->is_ioc4_misc_addr->sio_ir.raw), -readl (&soft->is_ioc4_misc_addr->sio_ies.raw), -readl (&soft->is_ioc4_misc_addr->other_ir.raw), -readl (&soft->is_ioc4_misc_addr->other_ies.raw)); - } }#ifdef DEBUG_INTERRUPTS {