Skip to contentSkip to conversation

IRQ type flags

RFC New Russell King 1 participant 1 message Oct 28, 2005 Arm (32-bit)

lore
Share & tools
lore
#0 lore raw

RFC 1/1 IRQ type flags

Hi,

Some ARM platforms have the ability to program the interrupt controller to detect various interrupt edges and/or levels. For some platforms, this is critical to setup correctly, particularly those which the setting is dependent on the device.

Currently, ARM drivers do (eg) the following:

	err = request_irq(irq, ...);

	set_irq_type(irq, IRQT_RISING);

However, if the interrupt has previously been programmed to be level sensitive (for whatever reason) then this will cause an interrupt storm.

Hence, if we combine set_irq_type() with request_irq(), we can then safely set the type prior to unmasking the interrupt. The unfortunate problem is that in order to support this, these flags need to be visible outside of the ARM architecture - drivers such as smc91x need these flags and they're cross-architecture.

Finally, the SA_TRIGGER_* flag passed to request_irq() should reflect the property that the device would like. The IRQ controller code should do its best to select the most appropriate supported mode.

Comments?

arch/arm/kernel/irq.c +14 -2
@@ -681,10 +681,16 @@ int setup_irq(unsigned int irq, struct i
 	 */
 	desc = irq_desc + irq;
 	spin_lock_irqsave(&irq_controller_lock, flags);
+#define SA_TRIGGER	(SA_TRIGGER_HIGH|SA_TRIGGER_LOW|\
+			 SA_TRIGGER_RISING|SA_TRIGGER_FALLING)
 	p = &desc->action;
 	if ((old = *p) != NULL) {
-		/* Can't share interrupts unless both agree to */
-		if (!(old->flags & new->flags & SA_SHIRQ)) {
+		/*
+		 * Can't share interrupts unless both agree to and are
+		 * the same type.
+		 */
+		if (!(old->flags & new->flags & SA_SHIRQ) ||
+		    (~old->flags & new->flags) & SA_TRIGGER) {
 			spin_unlock_irqrestore(&irq_controller_lock, flags);
 			return -EBUSY;
 		}
@@ -704,6 +710,12 @@ int setup_irq(unsigned int irq, struct i
 		desc->running = 0;
 		desc->pending = 0;
 		desc->disable_depth = 1;
+
+		if (new->flags & SA_TRIGGER) {
+			unsigned int type = new->flags & SA_TRIGGER;
+			desc->chip->set_type(irq, type);
+		}
+
 		if (!desc->noautoenable) {
 			desc->disable_depth = 0;
 			desc->chip->unmask(irq);
include/linux/signal.h +8 -0
@@ -18,6 +18,14 @@
 #define SA_PROBE		SA_ONESHOT
 #define SA_SAMPLE_RANDOM	SA_RESTART
 #define SA_SHIRQ		0x04000000
+/*
+ * As above, these correspond to the __IRQT defines in asm-arm/irq.h
+ * to select the interrupt line behaviour.
+ */
+#define SA_TRIGGER_HIGH		0x00000008
+#define SA_TRIGGER_LOW		0x00000004
+#define SA_TRIGGER_RISING	0x00000002
+#define SA_TRIGGER_FALLING	0x00000001
 
 /*
  * Real Time signals may be queued.