hwmon: Clarify the W83627THF VID
Subsystems (2)
PATCH 2/25 hwmon: Clarify the W83627THF VID
From: "Mark M. Hoffman" <[email protected]>
Content-Disposition: inline; filename=hwmon-w83627thf-vid-documentation-update.patch
This patch clarifies the W83627THF VID documentation.
Signed-off-by Mark M. Hoffman <[email protected]>
Signed-off-by Jean Delvare <[email protected]>
--- Documentation/hwmon/w83627hf | 19 +++++++++++-------- 1 file changed, 11 insertions(+), 8 deletions(-)
Documentation/hwmon/w83627hf +11 -8
@@ -54,13 +54,16 @@ use the w83781d driver. However this is not the preferred method now that this ISA driver has been developed. -Technically, the w83627thf does not support a VID reading. However, it's -possible or even likely that your mainboard maker has routed these signals -to a specific set of general purpose IO pins (the Asus P4C800-E is one such -board). The w83627thf driver now interprets these as VID. If the VID on -your board doesn't work, first see doc/vid in the lm_sensors package. If -that still doesn't help, email us at [email protected]. +The w83627_HF_ uses pins 110-106 as VID0-VID4. The w83627_THF_ uses the +same pins as GPIO[0:4]. Technically, the w83627_THF_ does not support a +VID reading. However the two chips have the identical 128 pin package. So, +it is possible or even likely for a w83627thf to have the VID signals routed +to these pins despite their not being labeled for that purpose. Therefore, +the w83627thf driver interprets these as VID. If the VID on your board +doesn't work, first see doc/vid in the lm_sensors package[1]. If that still +doesn't help, you may just ignore the bogus VID reading with no harm done. -For further information on this driver see the w83781d driver -documentation. +For further information on this driver see the w83781d driver documentation. + +[1] http://www2.lm-sensors.nu/~lm78/cvs/browse.cgi/lm_sensors2/doc/vid
Signature · 1 line
Jean Delvare