Skip to contentSkip to conversation

Booting problem !!

DISCUSSION nitesh ranjan 3 participants 3 messages Dec 8, 2005 – Dec 9, 2005

lore
Share & tools
lore
#0 lore raw

when I connect osk5912 and start minicom..it does not show anything..(earlier it was booting..)thr is no power on the ethernet leds .Also..in windows after connecting thr hypertrm .osk doesnot boot at all . What I did was ..loading my fresh compiled kernel uImage into osk5912..(version D)..an error has occured ..an flash was not erased at some location ..and wht i did.. I typed bootm ..then it loaded linux.. and after entering ..it hanged ..then.. i pressed reset button.Since then , thr is no booting ..at all ..nothing is being shown .
Plz suggest wht to do and what had happened :(

__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com

#1 lore raw

Maybe u-boot in osk is damaged by the "wild" kernel you need to recover osk by reflashing the u-boot try searching this mailling list, I am sure there are some infomations that will help you.

2005/12/8, nitesh ranjan <[email protected]>:

Quoted 24 lines

when I connect osk5912 and start minicom..it does not show anything..(earlier it was booting..)thr is no power on the ethernet leds .Also..in windows after connecting thr hypertrm .osk doesnot boot at all . What I did was ..loading my fresh compiled kernel uImage into osk5912..(version D)..an error has occured ..an flash was not erased at some location ..and wht i did.. I typed bootm ..then it loaded linux.. and after entering ..it hanged ..then.. i pressed reset button.Since then , thr is no booting ..at all ..nothing is being shown .
Plz suggest wht to do and what had happened :(

__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Linux-omap-open-source mailing list [email protected]
http://linux.omap.com/mailman/listinfo/linux-omap-open-source

#2 lore raw

Hi ....i hv just started working on omap5912.

And while trying to load the kernel image encountered the same problem.Theprocessor hanged after i gave the command bootm...........I had to reload
the uImage again . I am not sure whether it will help u or not but it may be becoz of the size of kernel that u entered may be different .In my case it was this.
But i m struck at the same point once again........I am using the procedure mentioned in the documentation that is provided with the kit but it says minicom does not work properly with uboot.....i saw in your mail that u r using minicom.........is it working fine?

Pls excuse me 4 my ignorance but i m confused how to enter kernel parameters .using hyperterminal........the command is
setenv bootargs console=ttys0,115200n8 noinitrd rw ip=dhcp root=/dev/nfs nfsroot=serverip:/home/username/montavista/filesys,nolock mem=30M saveenv
Is it jst a command to enter the parameters or it requires the linux system ON at that particular moment?

if yes then hw to communicate with linux on one system and hyperterminal on winxp of some other system..........does it require some configurational setup ?Or should i configure minicom for this purpose......? pls suggest ???

Quoted 30 lines

2005/12/8, nitesh ranjan <[email protected]>:

Quoted 15 lines

when I connect osk5912 and start minicom..it does not show anything..(earlier it was booting..)thr is no power on the ethernet leds .Also..in windows after connecting thr hypertrm .osk doesnot boot at all . What I did was ..loading my fresh compiled kernel uImage into osk5912..(version D)..an error has occured ..an flash was not erased at some location ..and wht i did.. I typed bootm ..then it loaded linux.. and after entering ..it hanged ..then.. i pressed reset button.Since then , thr is no booting ..at all ..nothing is being shown .
Plz suggest wht to do and what had happened :(

Quoted 9 lines

__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Linux-omap-open-source mailing list [email protected]
http://linux.omap.com/mailman/listinfo/linux-omap-open-source

_______________________________________________
Linux-omap-open-source mailing list
[email protected]
http://linux.omap.com/mailman/listinfo/linux-omap-open-source