raidreconf on raid-5, SATA, inf. Write Errors
Hi team,
I've had a 7-disk RAID-5 system running for months on a 2.6 kernel it it's been great. I had a need to expand, so I bought 4 more disks and I'd expanding using raidreconf from:
http://unthought.net/raidreconf/
I saw the warnings and - you guesses it - it's happened.
My reconf is going very slowly because I keep getting write problems (however it does *slowly* advance in progress) on 4 of my 11 disks. The 4 disks in question are all on the same SATA controller.
Some notes to point out:
- I ran a test expansion of 4 /dev/loop[0-4] to /dev/loop[0-8] RAID-5 and it worked, so my steps *should* work
- I ran SMARTCTL checks on all disks before doing this, all was clean
- I copied over 1TB of data to or from all these disks before I started, so this seems to be a net-new since I started raidreconf
- All the errors are coming from the same 4 disks which are on the same controller.
- I'm still running raidreconf because if I stop it, I will lose everything
I know I took on this risk when I started my conversion. But I'd like to get any pointers I can since my honeymoon photos are on there (sentimental value is priceless - insert divorce comments now).
Here are my questions:
- Is there something I should be looking out for that may suddenly cause these errors to show up (static, improper grounding points on the disk drives? anything?)
- Now that I'm seeing these messages show up every 5 sec or so, how can I reduce their frequency so it will not take 5 years to finish this expansion.
Any help would be hugely appreciated.
JLC