4 patches for 2.6.15

@@ -529,14 +529,15 @@ mv64xxx_i2c_probe(struct platform_device
 	i2c_set_adapdata(&drv_data->adapter, drv_data);
 
 	if (request_irq(drv_data->irq, mv64xxx_i2c_intr, 0,
-		MV64XXX_I2C_CTLR_NAME, drv_data)) {
-
-		dev_err(dev, "mv64xxx: Can't register intr handler "
-			"irq: %d\n", drv_data->irq);
+			MV64XXX_I2C_CTLR_NAME, drv_data)) {
+		dev_err(&drv_data->adapter.dev,
+			"mv64xxx: Can't register intr handler irq: %d\n",
+			drv_data->irq);
 		rc = -EINVAL;
 		goto exit_unmap_regs;
 	} else if ((rc = i2c_add_adapter(&drv_data->adapter)) != 0) {
-		dev_err(dev, "mv64xxx: Can't add i2c adapter, rc: %d\n", -rc);
+		dev_err(&drv_data->adapter.dev,
+			"mv64xxx: Can't add i2c adapter, rc: %d\n", -rc);
 		goto exit_free_irq;
 	}
 

@@ -155,7 +155,7 @@ static __init void unreachable_devices(v
 		addr = get_base_addr(0, 0, PCI_DEVFN(i, 0));
 		if (addr != 0)
 			pci_exp_set_dev_base(addr, 0, PCI_DEVFN(i, 0));
-		if (addr == 0 || readl((u32 __iomem *)addr) != val1)
+		if (addr == 0 || readl((u32 __iomem *)mmcfg_virt_addr) != val1)
 			set_bit(i, fallback_slots);
 		spin_unlock_irqrestore(&pci_config_lock, flags);
 	}

@@ -717,6 +717,7 @@ static int uhci_suspend(struct usb_hcd *
 	 * at the source, so we must turn off PIRQ.
 	 */
 	pci_write_config_word(to_pci_dev(uhci_dev(uhci)), USBLEGSUP, 0);
+	mb();
 	clear_bit(HCD_FLAG_HW_ACCESSIBLE, &hcd->flags);
 	uhci->hc_inaccessible = 1;
 	hcd->poll_rh = 0;

@@ -738,6 +739,7 @@ static int uhci_resume(struct usb_hcd *h
 	 * really don't want to keep a stale HCD_FLAG_HW_ACCESSIBLE=0
 	 */
 	set_bit(HCD_FLAG_HW_ACCESSIBLE, &hcd->flags);
+	mb();
 
 	if (uhci->rh_state == UHCI_RH_RESET)	/* Dead */
 		return 0;

@@ -1432,7 +1432,8 @@ static int usb_generic_suspend(struct de
 			mark_quiesced(intf);
 	} else {
 		// FIXME else if there's no suspend method, disconnect...
-		dev_warn(dev, "no %s?\n", "suspend");
+		dev_warn(dev, "no suspend for driver %s?\n", driver->name);
+		mark_quiesced(intf);
 		status = 0;
 	}
 	return status;

@@ -1460,8 +1461,10 @@ static int usb_generic_resume(struct dev
 	}
 
 	if ((dev->driver == NULL) ||
-	    (dev->driver_data == &usb_generic_driver_data))
+	    (dev->driver_data == &usb_generic_driver_data)) {
+		dev->power.power_state.event = PM_EVENT_FREEZE;
 		return 0;
+	}
 
 	intf = to_usb_interface(dev);
 	driver = to_usb_driver(dev->driver);

@@ -1481,7 +1484,7 @@ static int usb_generic_resume(struct dev
 			mark_quiesced(intf);
 		}
 	} else
-		dev_warn(dev, "no %s?\n", "resume");
+		dev_warn(dev, "no resume for driver %s?\n", driver->name);
 	return 0;
 }
 

@@ -109,7 +109,7 @@ static int slave_configure(struct scsi_d
 	 * data comes from.
 	 */
 	if (sdev->scsi_level < SCSI_2)
-		sdev->scsi_level = SCSI_2;
+		sdev->scsi_level = sdev->sdev_target->scsi_level = SCSI_2;
 
 	/* According to the technical support people at Genesys Logic,
 	 * devices using their chips have problems transferring more than

@@ -162,7 +162,7 @@ static int slave_configure(struct scsi_d
 		 * a Get-Max-LUN request, we won't lose much by setting the
 		 * revision level down to 2.  The only devices that would be
 		 * affected are those with sparse LUNs. */
-		sdev->scsi_level = SCSI_2;
+		sdev->scsi_level = sdev->sdev_target->scsi_level = SCSI_2;
 
 		/* USB-IDE bridges tend to report SK = 0x04 (Non-recoverable
 		 * Hardware Error) when any low-level error occurs,