Skip to contentSkip to conversation

conservative governor not working?

DISCUSSION Jan Kasprzak 1 participant 1 message Dec 22, 2005

lore
Share & tools
lore
#0 lore raw

Hi all,

I have tried to use the "conservative" cpufreq governor
on my Athlon64 X2 (dual-core), Tyan K8S board. When I set up the "ondemand" governor, it works as expected - under the load the CPU frequency is raised to maximum, and when the load stops, the frequency slowly returns back. When I switch to the "conservative" governor, it just stays on the same frequency all the time not depending whether there is a CPU load or not.

	I have 2.6.15-rc6 kernel, Fedora Core 4 (native x86_64),

and I do not touch the default values in /sys/devices/system/cpu/*/cpufreq except that setting a different governor. When the conservative governor is on, I have the following settings:

./conservative/freq_step 5
./conservative/ignore_nice 0 ./conservative/down_threshold 20 ./conservative/up_threshold 80 ./conservative/sampling_down_factor 5 ./conservative/sampling_rate 124000000 ./conservative/sampling_rate_min 62000000 ./conservative/sampling_rate_max 1870457856 ./scaling_cur_freq 1000000
./cpuinfo_cur_freq 1000000 ./scaling_available_frequencies 2200000 2000000 1800000 1000000 ./scaling_available_governors conservative ondemand performance ./scaling_driver powernow-k8
./scaling_governor conservative
./affected_cpus 0 1
./scaling_max_freq 2200000
./scaling_min_freq 1000000
./cpuinfo_max_freq 2200000
./cpuinfo_min_freq 1000000

Does anybody have working conservative governor? And with K8,
or dual-core K8?

Thanks,

-Yenya

Signature · 3 lines
| Jan "Yenya" Kasprzak  <kas at {fi.muni.cz - work | yenya.net - private}> |
| GPG: ID 1024/D3498839      Fingerprint 0D99A7FB206605D7 8B35FCDE05B18A5E |
| http://www.fi.muni.cz/~kas/    Journal: http://www.fi.muni.cz/~kas/blog/ |
Quoted 2 lines

Specs are a basis for _talking_about_ things. But they are _not_ a basis <
for implementing software. --Linus Torvalds <