spelling: s/appropiate/appropriate/
Subsystems (6)
PATCH 1/1 spelling: s/appropiate/appropriate/
Signed-off-by Adrian Bunk <[email protected]>
---
Documentation/cachetlb.txt | 2 +- Documentation/ioctl/hdio.txt | 2 +- Documentation/laptop-mode.txt | 2 +- Documentation/networking/sk98lin.txt | 2 +- Documentation/x86_64/boot-options.txt | 2 +- drivers/s390/scsi/zfcp_erp.c | 2 +- drivers/scsi/gdth.c | 2 +- sound/oss/opl3sa2.c | 2 +- 8 files changed, 8 insertions(+), 8 deletions(-)
Documentation/cachetlb.txt renamed from Documentation/cachetlb.txt.old +1 -1
@@ -136,7 +136,7 @@ 8) void lazy_mmu_prot_update(pte_t pte) This interface is called whenever the protection on any user PTEs change. This interface provides a notification - to architecture specific code to take appropiate action. + to architecture specific code to take appropriate action. Next, we have the cache flushing interfaces. In general, when Linux
Documentation/ioctl/hdio.txt renamed from Documentation/ioctl/hdio.txt.old +1 -1
@@ -946,7 +946,7 @@ This ioctl initializes the addresses and irq for a disk controller, probes for drives, and creates /proc/ide - interfaces as appropiate. + interfaces as appropriate.
Documentation/laptop-mode.txt renamed from Documentation/laptop-mode.txt.old +1 -1
@@ -357,7 +357,7 @@ # Read-ahead, in kilobytes READAHEAD=${READAHEAD:-'4096'} -# Shall we remount journaled fs. with appropiate commit interval? (1=yes) +# Shall we remount journaled fs. with appropriate commit interval? (1=yes) DO_REMOUNTS=${DO_REMOUNTS:-'1'} # And shall we add the "noatime" option to that as well? (1=yes)
Documentation/networking/sk98lin.txt renamed from Documentation/networking/sk98lin.txt.old +1 -1
@@ -91,7 +91,7 @@ with (M) 5. Execute the command "make modules". 6. Execute the command "make modules_install". - The appropiate modules will be installed. + The appropriate modules will be installed. 7. Reboot your system.
Documentation/x86_64/boot-options.txt renamed from Documentation/x86_64/boot-options.txt.old +1 -1
@@ -198,6 +198,6 @@ Misc - noreplacement Don't replace instructions with more appropiate ones + noreplacement Don't replace instructions with more appropriate ones for the CPU. This may be useful on asymmetric MP systems where some CPU have less capabilities than the others.
drivers/s390/scsi/zfcp_erp.c renamed from drivers/s390/scsi/zfcp_erp.c.old +1 -1
@@ -3403,7 +3403,7 @@/** * zfcp_erp_action_cleanup * -* Register unit with scsi stack if appropiate and fix reference counts. +* Register unit with scsi stack if appropriate and fix reference counts. * Note: Temporary units are not registered with scsi stack. */ static void
drivers/scsi/gdth.c renamed from drivers/scsi/gdth.c.old +1 -1
@@ -328,7 +328,7 @@* hdr_channel:x x - number of virtual bus for host drives * shared_access:Y disable driver reserve/release protocol to * access a shared resource from several nodes, -* appropiate controller firmware required +* appropriate controller firmware required * shared_access:N enable driver reserve/release protocol * probe_eisa_isa:Y scan for EISA/ISA controllers * probe_eisa_isa:N do not scan for EISA/ISA controllers
sound/oss/opl3sa2.c renamed from sound/oss/opl3sa2.c.old +1 -1
@@ -530,7 +530,7 @@if (hw_config->slots[0 ] !=-1 ) {/* Did the MSS driver install? */ if (num_mixers == (initial_mixers +1 )) { -/* The MSS mixer is installed, reroute mixers appropiately */ +/* The MSS mixer is installed, reroute mixers appropriately */ AD1848_REROUTE (SOUND_MIXER_LINE1 ,SOUND_MIXER_CD );AD1848_REROUTE (SOUND_MIXER_LINE2 ,SOUND_MIXER_SYNTH );AD1848_REROUTE (SOUND_MIXER_LINE3 ,SOUND_MIXER_LINE );