Skip to contentSkip to conversation

cpufreq_conservative: cpu always in slowest mode even under high load

Bug 5353 [email protected] 1 participant 1 message Jan 26, 2006

lore
Share & tools
lore
#0 lore raw

http://bugzilla.kernel.org/show_bug.cgi?id=5353

------- Additional Comments From [email protected] 2006-01-26 13:16 ------- I've seen something that may be related on a Dell Inspiron 630m.

When the plug gets pulled to switch to batteries, scaling_max_frequency drops to the lowest speed (and usually the cpu speed drops as well, but not always - so sometimes the cpu speed is actually faster than the policy limits). Then about 15 seconds later a CPU acpi event occurs and the scaling_max_frequency pops back to where it was. I don't think this is due to any user space tools. It happens exactly the same way if laptop_mode is running or not and if acpid is running or not.

If I try to set scaling_max_frequency to some other frequency value with echo -n (or with cpufreq-set) the new value is ignored. After the acpi CPU event, exactly the same command does its job.

This happens with any of the governors running (tried userspace, conservative, performance).

Sometimes conservative seems to get confused - the only consistent way I've seen to make it confused is to start to hibernate, and then pull the plug. After starting up on ac (using swsusp2) the governor won't make any changes to the speed. Pulling the plug actually does seem to get it unconfused.

I've tried speedstep_centrino with freq_table as well as acpi_cpufreq and see the same behaviour either way.

I have 2.6.15 with swsusp2

------- You are receiving this mail because: ------- You are the assignee for the bug, or are watching the assignee.