Skip to contentSkip to conversation

AGP serverworks chipset not being initializated properly?

DISCUSSION Diego Calleja 2 participants 2 messages Feb 13, 2006

lore
Share & tools
lore
#0 lore raw

For a while, I've been having this on my dmesg:

agpgart: Xorg tried to set rate=x12. Setting to AGP3 x8 mode.
agpgart: Putting AGP V2 device at 0000:00:00.1 into 2x mode
agpgart: Putting AGP V2 device at 0000:01:00.0 into 2x mode [drm] Loading R200 Microcode

This is really weird since my motherboard (CNB20HE chipset) only supports 2x AGP cards and my xorg.conf file has this:

Section "Device"
Identifier "RADEON9200SE"
Driver "radeon"
Option "AGPMode" "2"
EndSection

Looking at the code I found out that the code path being run to get this printk is:
------------------------------------------------------------------

    /* Check to see if we are operating in 3.0 mode */
    if (agp_bridge->mode & AGPSTAT_MODE_3_0)     
	agp_v3_parse_one(&requested_mode, &bridge_agpstat, &vga_agpstat); <----------
    else
	agp_v2_parse_one(&requested_mode, &bridge_agpstat, &vga_agpstat);

------------------------------------------------------------------

so it looks like agp_brige->mode is not being initializated properly, it is sworks-agp.c:serverworks_configure() who initializates it in my box so something has to be wrong with one of these 2 lines?:
------------------------------------------------------------------

        agp_bridge->capndx = pci_find_capability(serverworks_private.svrwrks_dev, PCI_CAP_ID_AGP);

        /* Fill in the mode register */
        pci_read_config_dword(serverworks_private.svrwrks_dev,
                              agp_bridge->capndx+PCI_AGP_STATUS, &agp_bridge->mode);

------------------------------------------------------------------

What is going on, is this a know bug, should I just ignore it (it doesn't harms anything), file a bugzilla bug? My dmesg says:
Linux agpgart interface v0.101 (c) Dave Jones
agpgart: AGP aperture is 128M @ 0xd0000000
agpgart: Detected ServerWorks CNB20HE chipset: No AGP present.
agpgart: Detected ServerWorks CNB20HE chipset: No AGP present.

Full lspci output is included.

#1 lore raw
Quoted 9 lines · Diego Calleja

For a while, I've been having this on my dmesg:

agpgart: Xorg tried to set rate=x12. Setting to AGP3 x8 mode.
agpgart: Putting AGP V2 device at 0000:00:00.1 into 2x mode
agpgart: Putting AGP V2 device at 0000:01:00.0 into 2x mode [drm] Loading R200 Microcode

This is really weird since my motherboard (CNB20HE chipset) only supports 2x AGP cards and my xorg.conf file has this:

CNB20HE is unsupported (The failure message should actually be a little better, I'll go fix that).

Docs on this chipset aren't publically available, so it's unlikely to happen any time soon.

Dave