Driver to remember ethernet MAC values: NSLU2 support
Subsystems (5)
RFC PATCH 2/2 Driver to remember ethernet MAC values: NSLU2 support
From: John Bowler <[email protected]>
Implement maclist support for the Linksys NSLU2. The MAC address is read from the RedBoot partition in flash.
Signed-off-by John Bowler <[email protected]>
Signed-off-by Martin Michlmayr <[email protected]>
Signed-off-by Alessandro Zummo <[email protected]>
Signed-off-by Rod Whitby <[email protected]>
--
arch/arm/mach-ixp4xx/Kconfig | 4 +-- arch/arm/mach-ixp4xx/nslu2-setup.c | 39 +++++++++++++++++++++++++++++++++++++ 2 files changed, 41 insertions(+), 2 deletions(-)
arch/arm/mach-ixp4xx/nslu2-setup.c +39 -0
@@ -16,11 +16,14 @@#include <linux/kernel.h> #include <linux/serial.h> #include <linux/serial_8250.h> +#include <linux/mtd/mtd.h> #include <asm/mach-types.h> #include <asm/mach/arch.h> #include <asm/mach/flash.h> +#include <net/maclist.h> +static struct flash_platform_data nslu2_flash_data = { .map_name ="cfi_probe" , .width =2 ,
@@ -117,6 +120,37 @@ static void nslu2_power_off(void)gpio_line_set (NSLU2_PO_GPIO ,IXP4XX_GPIO_HIGH ); } +/* +* When the RedBoot partition is added the MAC address is read from +* it. +*/ +static void nslu2_flash_add (struct mtd_info *mtd) { +if (strcmp (mtd->name,"RedBoot" ) ==0 ) { +size_t retlen; +u_char mac[6 ]; + +/* The MAC is at a known offset... */ +if (mtd->read (mtd,0x3FFB0 ,6 , &retlen, mac) ==0 && retlen ==6 ) { +printk (KERN_INFO "NSLU2 MAC: %.2x:%.2x:%.2x:%.2x:%.2x:%.2x\n" , + mac[0 ], mac[1 ], mac[2 ], mac[3 ], mac[4 ], mac[5 ]); +maclist_add (mac); + }else { +printk (KERN_ERR "NSLU2 MAC: read failed\n" ); + } + } +} + +/* +* Nothing to do on remove at present. +*/ +static void nslu2_flash_remove (struct mtd_info *mtd) { +} + +static struct mtd_notifier nslu2_flash_notifier = { + .add = nslu2_flash_add, + .remove = nslu2_flash_remove, +}; +static void __init nslu2_init (void ) {/* The NSLU2 has a 33MHz crystal on board - 1.01% different
@@ -124,6 +158,11 @@ static void __init nslu2_init(void)*/ ixp4xx_set_board_tick_rate (66000000 ); +/* The flash has an ethernet MAC embedded in it which we need, +* that is all this notifier does. +*/ +register_mtd_user (&nslu2_flash_notifier); +ixp4xx_sys_init (); pm_power_off = nslu2_power_off;
Signature · 2 lines
Martin Michlmayr http://www.cyrius.com/