ALSA HDA Intel stoped to work in 2.6.16-*
I can confirm this as well.
DEVICE:
Intel Corporation 82801G (ICH7 Family) High Definition Audio Controller (rev 01)
SYMPTOMS:
1. No sound.
2. kernel: azx_get_response timeout
messages in system log
3. Doing modprobe -r snd_hda_intel and then modprobe snd_hda_intel produces "general protection fault: 0000 [1] SMP" message.
I think I have seen another thread on this.
At Mon, 27 Feb 2006 09:00:13 -0600,
Quoted 11 lines · S. Umar
I can confirm this as well.
DEVICE:
Intel Corporation 82801G (ICH7 Family) High Definition Audio Controller (rev 01)SYMPTOMS:
1. No sound.
2. kernel:azx_get_responsetimeout
messages in system log
It's a known interrupt problem.
The latest version on ALSA CVS has a workaround for this.
Quoted 2 lines
3. Doing modprobe -r
snd_hda_inteland then modprobesnd_hda_intelproduces "general protection fault: 0000 [1] SMP" message.
Not sure about this.
You didn't get this in 2.6.15 or earlier?
Takashi
Quoted 10 lines · Takashi Iwai
At Mon, 27 Feb 2006 09:00:13 -0600,
Quoted 8 lines · S. Umar
I can confirm this as well.
DEVICE:
Intel Corporation 82801G (ICH7 Family) High Definition Audio Controller (rev 01)SYMPTOMS:
Quoted 8 lines
Quoted 3 lines
1. No sound.
2. kernel:azx_get_responsetimeout
messages in system logIt's a known interrupt problem.
The latest version on ALSA CVS has a workaround for this.
...
Shouldn't this fix go into 2.6.16?
Quoted 1 line
Takashi
cu
Adrian
Signature · 4 lines
"Is there not promise of rain?" Ling Tan asked suddenly out
of the darkness. There had been need of rain for many days.
"Only a promise," Lao Er said.
Pearl S. Buck - Dragon SeedAt Sat, 4 Mar 2006 15:46:25 +0100,
Quoted 16 lines · Adrian Bunk
Quoted 14 lines · Takashi Iwai
At Mon, 27 Feb 2006 09:00:13 -0600,
Quoted 11 lines · S. Umar
I can confirm this as well.
DEVICE:
Intel Corporation 82801G (ICH7 Family) High Definition Audio Controller (rev 01)SYMPTOMS:
1. No sound.
2. kernel:azx_get_responsetimeout
messages in system log
Quoted 6 lines
Quoted 4 lines
It's a known interrupt problem.
The latest version on ALSA CVS has a workaround for this.
...Shouldn't this fix go into 2.6.16?
Unfortunately it's involved with many other patches (especially semahpore->mutex ones) and hard to cherry-pick...
Takashi
Quoted 4 lines · Takashi Iwai
Quoted 1 line
Shouldn't this fix go into 2.6.16?
Unfortunately it's involved with many other patches (especially
semahpore->mutexones) and hard to cherry-pick...
I could prepare another patch just to fix it and then put it in on 2.6.16.
Signature · 8 lines
O T A V I O S A L V A D O R --------------------------------------------- E-mail: [email protected] UIN: 5906116 GNU/Linux User: 239058 GPG ID: 49A5F855 Home Page: http://www.freedom.ind.br/otavio --------------------------------------------- "Microsoft gives you Windows ... Linux gives you the whole house."
At Mon, 06 Mar 2006 13:19:30 -0300,
Quoted 10 lines · Otavio Salvador
Quoted 4 lines · Takashi Iwai
Quoted 1 line
Shouldn't this fix go into 2.6.16?
Unfortunately it's involved with many other patches (especially
semahpore->mutexones) and hard to cherry-pick...I could prepare another patch just to fix it and then put it in on 2.6.16.
In the above I meant the patch to do the workaround of azx_get_timeout() automatically. The patch to change the default model for your laptop is another thing, which I posted already.
Takashi
Quoted 11 lines · Takashi Iwai
At Mon, 06 Mar 2006 13:19:30 -0300,
Quoted 8 lines · Otavio Salvador
Quoted 4 lines · Takashi Iwai
Quoted 1 line
Shouldn't this fix go into 2.6.16?
Unfortunately it's involved with many other patches (especially
semahpore->mutexones) and hard to cherry-pick...I could prepare another patch just to fix it and then put it in on 2.6.16.
I have a DELL E1705 Laptop and snd-intel-hda used to work for me in 2.6.15 - it no longer works (Silence, no sound, no errors in dmesg) with 2.6.16-rc6.
I have tried to load snd_hda_intel with model=basic but even then it did not work for me.
cat /proc/asound/cards
0 [01cd ]: HDA-Intel - HDA Intel
HDA Intel at 0xdfebc000 irq 233
cat /proc/asound/01cd/
codec#0 codec#1 id oss_mixer pcm0c/ pcm0p/ pcm1p/
paragw@penguin ~ $ cat /proc/asound/01cd/codec#0
Codec: SigmaTel STAC9200
Address: 0
Vendor Id: 0x83847690
Subsystem Id: 0x102801cd
Revision Id: 0x102201
Default PCM: rates 0x7e0, bits 0x0e, types 0x1
Default Amp-In caps: N/A
Default Amp-Out caps: ofs=0x1f, nsteps=0x1f, stepsize=0x05, mute=1 Node 0x02 [Audio Output] wcaps 0xd0401: Stereo
Power: 0x0
Node 0x03 [Audio Input] wcaps 0x1d0541: Stereo
Power: 0x0
Connection: 1
0x0a
Node 0x04 [Audio Input] wcaps 0x140311: Stereo Digital
PCM: rates 0x160, bits 0x0e, types 0x5
Connection: 1
0x08Node 0x05 [Audio Output] wcaps 0x40211: Stereo Digital
PCM: rates 0x1e0, bits 0x0e, types 0x5
Node 0x06 [Vendor Defined Widget] wcaps 0xf30201: Stereo Digital Node 0x07 [Audio Selector] wcaps 0x300901: Stereo
Connection: 3
0x02* 0x08 0x0a
Node 0x08 [Pin Complex] wcaps 0x430681: Stereo Digital
Pincap 0x0810024: IN
Pin Default 0x40c003fa: [N/A] SPDIF In at Ext N/A
Conn = Unknown, Color = Unknown
Pin-ctls: 0x00:
Power: 0x0
Node 0x09 [Pin Complex] wcaps 0x400301: Stereo Digital
Pincap 0x0810: OUT
Pin Default 0x01441340: [Jack] SPDIF Out at Ext Rear
Conn = RCA, Color = Black
Pin-ctls: 0x40: OUT
Connection: 2
0x05* 0x0a
Node 0x0a [Audio Selector] wcaps 0x30090d: Stereo Amp-Out
Amp-Out caps: ofs=0x00, nsteps=0x0f, stepsize=0x05, mute=1 Amp-Out vals: [0x80 0x80]
Connection: 1
0x0c
Node 0x0b [Audio Selector] wcaps 0x300105: Stereo Amp-Out
Amp-Out caps: N/A
Amp-Out vals: [0x9f 0x9f]
Connection: 1
0x07
Node 0x0c [Audio Selector] wcaps 0x30010d: Stereo Amp-Out
Amp-Out caps: ofs=0x00, nsteps=0x04, stepsize=0x27, mute=0 Amp-Out vals: [0x00 0x00]
Connection: 5
0x10* 0x0f 0x0e 0x0d 0x12
Node 0x0d [Pin Complex] wcaps 0x400181: Stereo
Pincap 0x083f: IN OUT HP
Pin Default 0x0421421f: [Jack] HP Out at Ext Right
Conn = 1/8, Color = Green
Pin-ctls: 0x00:
Connection: 1
0x0b
Node 0x0e [Pin Complex] wcaps 0x400181: Stereo
Pincap 0x083f: IN OUT HP
Pin Default 0x90170310: [Fixed] Speaker at Int N/A
Conn = Analog, Color = Unknown
Pin-ctls: 0x00:
Connection: 1
0x0b
Node 0x0f [Pin Complex] wcaps 0x400181: Stereo
Pincap 0x0837: IN OUT
Pin Default 0x408003fb: [N/A] Line In at Ext N/A
Conn = Unknown, Color = Unknown
Pin-ctls: 0x20: IN
Connection: 1
0x0b
Node 0x10 [Pin Complex] wcaps 0x400181: Stereo
Pincap 0x081737: IN OUT
Pin Default 0x04a1102e: [Jack] Mic at Ext Right
Conn = 1/8, Color = Black
Pin-ctls: 0x20: IN
Connection: 1
0x0b
Node 0x11 [Pin Complex] wcaps 0x400104: Mono Amp-Out
Amp-Out caps: N/A
Amp-Out vals: [0x00]
Pincap 0x0810: OUT
Pin Default 0x90170311: [Fixed] Speaker at Int N/A
Conn = Analog, Color = Unknown
Pin-ctls: 0x00:
Connection: 1
0x13
Node 0x12 [Pin Complex] wcaps 0x400001: Stereo
Pincap 0x0820: IN
Pin Default 0x403003fc: [N/A] CD at Ext N/A
Conn = Unknown, Color = Unknown
Pin-ctls: 0x20: IN
Node 0x13 [Audio Mixer] wcaps 0x200100: Mono
Connection: 1
0x07
Node 0x14 [Beep Generator Widget] wcaps 0x70000c: Mono Amp-Out
Amp-Out caps: ofs=0x03, nsteps=0x03, stepsize=0x17, mute=1 Amp-Out vals: [0x00]
cat /proc/asound/01cd/codec#1
Codec: Generic 14f1 ID 2bfa
Address: 1
Vendor Id: 0x14f12bfa
Subsystem Id: 0x14f100c3
Revision Id: 0x90000
Parag