Skip to contentSkip to conversation

Rx-buffer overlow

U-Boot-Users Josef Angermeier 2 participants 2 messages Feb 28, 2006

lore
Share & tools
lore
#0 lore raw

Dear u-boot-users,

I am verly lucky, that i got u-boot running on my custom MPC875-board. Just a few things make still some trouble:

the ping-command (and all other network transfer commands) in the u-boot shell often doesn't work, and the following debug output is generated:

fec_recv[249] err: 802
fec_recv[249] err: 2802
fec_recv[249] err: 802

According to the Rx-buffer-status bits, an overlow takes place. So ping just works if there is less network traffic. But why ? - is the receive buffer to small, the CPU to slow ?

thanks for your advices,
best regards

Josef

#1 lore raw
Quoted 8 lines · In message <20060228081735.GA4849@false> you wrote:

fec_recv[249] err: 802
fec_recv[249] err: 2802
fec_recv[249] err: 802

According to the Rx-buffer-status bits, an overlow takes place. So ping just works if there is less network traffic. But why ? - is the receive buffer to small, the CPU to slow ?

At which clock frequency are you running your CPU?

Best regards,

Wolfgang Denk

Signature · 3 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Memories of you remind me of you.                   - Karl Lehenbauer